Add flow control support flags to gianfar's capabilities
The phy device supports 802.3x flow control, but the specific flags are not set
in the phy initialisation code. Flow control flags need to be added to the
supported capabilities of the phydev by the driver.
This is needed in order for ethtool to work ('ethtool -A' code checks for these
flags)
Signed-off-by: Pavaluca Matei <matei.pavaluca@freescale.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/freescale/gianfar.c b/drivers/net/ethernet/freescale/gianfar.c
index 4fdf0aa..2485b74 100644
--- a/drivers/net/ethernet/freescale/gianfar.c
+++ b/drivers/net/ethernet/freescale/gianfar.c
@@ -1687,6 +1687,9 @@
priv->phydev->supported &= (GFAR_SUPPORTED | gigabit_support);
priv->phydev->advertising = priv->phydev->supported;
+ /* Add support for flow control, but don't advertise it by default */
+ priv->phydev->supported |= (SUPPORTED_Pause | SUPPORTED_Asym_Pause);
+
return 0;
}