be2net: add code to display default value of tx rate for VFs
This change will allow the default value of tx rate to be displayed
when ip link show is called on a PF interface.
Signed-off-by: Ajit Khaparde <ajit.khaparde@emulex.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/benet/be_main.c b/drivers/net/benet/be_main.c
index 77a6e7e..3529400 100644
--- a/drivers/net/benet/be_main.c
+++ b/drivers/net/benet/be_main.c
@@ -3082,9 +3082,22 @@
netif_carrier_off(netdev);
if (be_physfn(adapter) && adapter->sriov_enabled) {
+ u8 mac_speed;
+ bool link_up;
+ u16 vf, lnk_speed;
+
status = be_vf_eth_addr_config(adapter);
if (status)
goto unreg_netdev;
+
+ for (vf = 0; vf < num_vfs; vf++) {
+ status = be_cmd_link_status_query(adapter, &link_up,
+ &mac_speed, &lnk_speed, vf + 1);
+ if (!status)
+ adapter->vf_cfg[vf].vf_tx_rate = lnk_speed * 10;
+ else
+ goto unreg_netdev;
+ }
}
dev_info(&pdev->dev, "%s port %d\n", nic_name(pdev), adapter->port_num);