drivers: net: cpsw-phy-sel: add dev_warn() for unsupported PHY mode
The cpsw-phy-sel driver supports only MII, RMII, and RGMII PHY modes,
and silently handled any other values as if MII was specified. In a
case where the PHY mode was incorrectly specified, or a bug elsewhere,
there would be no indication of a problem. If MII was the correct mode,
then this will go unnoticed, otherwise the symptom will be a failure
to transmit/receive data over the RMII/RGMII link.
Add a dev_warn() to make this condition obvious and provide a
breadcrumb to follow.
Cc: Mugunthan V N <mugunthanvnm@ti.com>
Signed-off-by: David Rivshin <drivshin@allworx.com>
Acked-by: Mugunthan V N <mugunthanvnm@ti.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/ti/cpsw-phy-sel.c b/drivers/net/ethernet/ti/cpsw-phy-sel.c
index e9cc61e..c3e85ac 100644
--- a/drivers/net/ethernet/ti/cpsw-phy-sel.c
+++ b/drivers/net/ethernet/ti/cpsw-phy-sel.c
@@ -63,8 +63,12 @@
mode = AM33XX_GMII_SEL_MODE_RGMII;
break;
- case PHY_INTERFACE_MODE_MII:
default:
+ dev_warn(priv->dev,
+ "Unsupported PHY mode: \"%s\". Defaulting to MII.\n",
+ phy_modes(phy_mode));
+ /* fallthrough */
+ case PHY_INTERFACE_MODE_MII:
mode = AM33XX_GMII_SEL_MODE_MII;
break;
};
@@ -106,8 +110,12 @@
mode = AM33XX_GMII_SEL_MODE_RGMII;
break;
- case PHY_INTERFACE_MODE_MII:
default:
+ dev_warn(priv->dev,
+ "Unsupported PHY mode: \"%s\". Defaulting to MII.\n",
+ phy_modes(phy_mode));
+ /* fallthrough */
+ case PHY_INTERFACE_MODE_MII:
mode = AM33XX_GMII_SEL_MODE_MII;
break;
};