ARM: AB3550 board configuration and irq for U300
This patch adds the i2c board configuration needed for the
Mixed Signal chip AB3550. It also adds the irq numbers needed
for the irq_chip implementation.
Signed-off-by: Mattias Wallin <mattias.wallin@stericsson.com>
Signed-off-by: Linus Walleij <linus.walleij@stericsson.com>
Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
diff --git a/arch/arm/mach-u300/i2c.c b/arch/arm/mach-u300/i2c.c
index d893ee0..f0394ba 100644
--- a/arch/arm/mach-u300/i2c.c
+++ b/arch/arm/mach-u300/i2c.c
@@ -46,6 +46,7 @@
/* BUCK SLEEP 0xAC: 1.05V, Not used, SLEEP_A and B, Not used */
#define BUCK_SLEEP_SETTING 0xAC
+#ifdef CONFIG_AB3100_CORE
static struct regulator_consumer_supply supply_ldo_c[] = {
{
.dev_name = "ab3100-codec",
@@ -253,14 +254,68 @@
LDO_D_SETTING,
},
};
+#endif
+
+#ifdef CONFIG_AB3550_CORE
+static struct abx500_init_settings ab3550_init_settings[] = {
+ {
+ .bank = 0,
+ .reg = AB3550_IMR1,
+ .setting = 0xff
+ },
+ {
+ .bank = 0,
+ .reg = AB3550_IMR2,
+ .setting = 0xff
+ },
+ {
+ .bank = 0,
+ .reg = AB3550_IMR3,
+ .setting = 0xff
+ },
+ {
+ .bank = 0,
+ .reg = AB3550_IMR4,
+ .setting = 0xff
+ },
+ {
+ .bank = 0,
+ .reg = AB3550_IMR5,
+ /* The two most significant bits are not used */
+ .setting = 0x3f
+ },
+};
+
+static struct ab3550_platform_data ab3550_plf_data = {
+ .irq = {
+ .base = IRQ_AB3550_BASE,
+ .count = (IRQ_AB3550_END - IRQ_AB3550_BASE + 1),
+ },
+ .dev_data = {
+ },
+ .init_settings = ab3550_init_settings,
+ .init_settings_sz = ARRAY_SIZE(ab3550_init_settings),
+};
+#endif
static struct i2c_board_info __initdata bus0_i2c_board_info[] = {
+#if defined(CONFIG_AB3550_CORE)
+ {
+ .type = "ab3550",
+ .addr = 0x4A,
+ .irq = IRQ_U300_IRQ0_EXT,
+ .platform_data = &ab3550_plf_data,
+ },
+#elif defined(CONFIG_AB3100_CORE)
{
.type = "ab3100",
.addr = 0x48,
.irq = IRQ_U300_IRQ0_EXT,
.platform_data = &ab3100_plf_data,
},
+#else
+ { },
+#endif
};
static struct i2c_board_info __initdata bus1_i2c_board_info[] = {