USB: EHCI: Safe endianness for transfer buffers after reset in case of HUB with TT
This patch fixes the endianness select for transfer buffers in EHCI
controllers that have Transaction Translator built in the hub. Also I
cleaned it up to make rid of magic numbers.
Signed-off-by: Vladimir Barinov <vbarinov@ru.mvista.com>
Cc: <david-b@pacbell.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/usb/host/ehci-hcd.c b/drivers/usb/host/ehci-hcd.c
index 889c202..a205a53 100644
--- a/drivers/usb/host/ehci-hcd.c
+++ b/drivers/usb/host/ehci-hcd.c
@@ -201,9 +201,15 @@
u32 __iomem *reg_ptr;
u32 tmp;
- reg_ptr = (u32 __iomem *)(((u8 __iomem *)ehci->regs) + 0x68);
+ reg_ptr = (u32 __iomem *)(((u8 __iomem *)ehci->regs) + USBMODE);
tmp = ehci_readl(ehci, reg_ptr);
- tmp |= 0x3;
+ tmp |= USBMODE_CM_HC;
+ /* The default byte access to MMR space is LE after
+ * controller reset. Set the required endian mode
+ * for transfer buffers to match the host microprocessor
+ */
+ if (ehci_big_endian_mmio(ehci))
+ tmp |= USBMODE_BE;
ehci_writel(ehci, tmp, reg_ptr);
}
diff --git a/drivers/usb/host/ehci.h b/drivers/usb/host/ehci.h
index 4d61710..2c68a04 100644
--- a/drivers/usb/host/ehci.h
+++ b/drivers/usb/host/ehci.h
@@ -302,6 +302,12 @@
#define PORT_RWC_BITS (PORT_CSC | PORT_PEC | PORT_OCC)
} __attribute__ ((packed));
+#define USBMODE 0x68 /* USB Device mode */
+#define USBMODE_SDIS (1<<3) /* Stream disable */
+#define USBMODE_BE (1<<2) /* BE/LE endianness select */
+#define USBMODE_CM_HC (3<<0) /* host controller mode */
+#define USBMODE_CM_IDLE (0<<0) /* idle state */
+
/* Appendix C, Debug port ... intended for use with special "debug devices"
* that can help if there's no serial console. (nonstandard enumeration.)
*/