net: dsa: bcm_sf2: Do not override speed settings
The SF2 driver currently overrides speed settings for its port
configured using a fixed PHY, this is both unnecessary and incorrect,
because we keep feedback to the hardware parameters that we read from
the PHY device, which in the case of a fixed PHY cannot possibly change
speed.
This is a required change to allow the fixed PHY code to allow
registering a PHY with a link configured as DOWN by default and avoid
some sort of circular dependency where we require the link_update
callback to run to program the hardware, and we then utilize the fixed
PHY parameters to program the hardware with the same settings.
Fixes: 246d7f773c13 ("net: dsa: add Broadcom SF2 switch driver")
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/dsa/bcm_sf2.c b/drivers/net/dsa/bcm_sf2.c
index 972982f..3297604 100644
--- a/drivers/net/dsa/bcm_sf2.c
+++ b/drivers/net/dsa/bcm_sf2.c
@@ -890,15 +890,11 @@
struct fixed_phy_status *status)
{
struct bcm_sf2_priv *priv = ds_to_priv(ds);
- u32 duplex, pause, speed;
+ u32 duplex, pause;
u32 reg;
duplex = core_readl(priv, CORE_DUPSTS);
pause = core_readl(priv, CORE_PAUSESTS);
- speed = core_readl(priv, CORE_SPDSTS);
-
- speed >>= (port * SPDSTS_SHIFT);
- speed &= SPDSTS_MASK;
status->link = 0;
@@ -933,18 +929,6 @@
reg &= ~LINK_STS;
core_writel(priv, reg, CORE_STS_OVERRIDE_GMIIP_PORT(port));
- switch (speed) {
- case SPDSTS_10:
- status->speed = SPEED_10;
- break;
- case SPDSTS_100:
- status->speed = SPEED_100;
- break;
- case SPDSTS_1000:
- status->speed = SPEED_1000;
- break;
- }
-
if ((pause & (1 << port)) &&
(pause & (1 << (port + PAUSESTS_TX_PAUSE_SHIFT)))) {
status->asym_pause = 1;