at803x: fix reset handling
The driver of course "knows" that the chip's reset signal is active low,
so it drives the GPIO to 0 to reset the PHY and to 1 otherwise; however
all this will only work iff the GPIO is specified as active-high in the
device tree! I think both the driver and the device trees (if there are
any -- I was unable to find them) need to be fixed in this case...
Fixes: 13a56b449325 ("net: phy: at803x: Add support for hardware reset")
Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Acked-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/phy/at803x.c b/drivers/net/phy/at803x.c
index 1e901c7..d7f03fa 100644
--- a/drivers/net/phy/at803x.c
+++ b/drivers/net/phy/at803x.c
@@ -277,7 +277,7 @@
if (!priv)
return -ENOMEM;
- gpiod_reset = devm_gpiod_get_optional(dev, "reset", GPIOD_OUT_HIGH);
+ gpiod_reset = devm_gpiod_get_optional(dev, "reset", GPIOD_OUT_LOW);
if (IS_ERR(gpiod_reset))
return PTR_ERR(gpiod_reset);
@@ -362,10 +362,10 @@
at803x_context_save(phydev, &context);
- gpiod_set_value(priv->gpiod_reset, 0);
- msleep(1);
gpiod_set_value(priv->gpiod_reset, 1);
msleep(1);
+ gpiod_set_value(priv->gpiod_reset, 0);
+ msleep(1);
at803x_context_restore(phydev, &context);