[PATCH] myri10ge - Use dev_info() when printing parameters after probe
Displaying the interface name when listing the device parameters
at the end of myri10ge_probe is not a good idea since udev might
rename the interface soon afterwards.
Print the bus id instead, using dev_info().
Signed-off-by: Brice Goglin <brice@myri.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/myri10ge/myri10ge.c b/drivers/net/myri10ge/myri10ge.c
index 8345e4f..abb5dd57 100644
--- a/drivers/net/myri10ge/myri10ge.c
+++ b/drivers/net/myri10ge/myri10ge.c
@@ -2734,11 +2734,10 @@
dev_err(&pdev->dev, "register_netdev failed: %d\n", status);
goto abort_with_irq;
}
-
- printk(KERN_INFO "myri10ge: %s: %s IRQ %d, tx bndry %d, fw %s, WC %s\n",
- netdev->name, (mgp->msi_enabled ? "MSI" : "xPIC"),
- pdev->irq, mgp->tx.boundary, mgp->fw_name,
- (mgp->mtrr >= 0 ? "Enabled" : "Disabled"));
+ dev_info(dev, "%s IRQ %d, tx bndry %d, fw %s, WC %s\n",
+ (mgp->msi_enabled ? "MSI" : "xPIC"),
+ pdev->irq, mgp->tx.boundary, mgp->fw_name,
+ (mgp->mtrr >= 0 ? "Enabled" : "Disabled"));
return 0;