phy: rockchip-emmc: configure frequency range and drive impedance
Signal integrity analysis has suggested we set these values. Do this in
power_on(), so that they get reconfigured after suspend/resume.
Signed-off-by: Shawn Lin <shawn.lin@rock-chips.com>
Signed-off-by: Brian Norris <briannorris@chromium.org>
Signed-off-by: Douglas Anderson <dianders@chromium.org>
Acked-by: Kishon Vijay Abraham I <kishon@ti.com>
Tested-by: Heiko Stuebner <heiko@sntech.de>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
diff --git a/drivers/phy/phy-rockchip-emmc.c b/drivers/phy/phy-rockchip-emmc.c
index 48cbe69..f2f75cf 100644
--- a/drivers/phy/phy-rockchip-emmc.c
+++ b/drivers/phy/phy-rockchip-emmc.c
@@ -56,6 +56,19 @@
#define PHYCTRL_DLLRDY_SHIFT 0x5
#define PHYCTRL_DLLRDY_DONE 0x1
#define PHYCTRL_DLLRDY_GOING 0x0
+#define PHYCTRL_FREQSEL_200M 0x0
+#define PHYCTRL_FREQSEL_50M 0x1
+#define PHYCTRL_FREQSEL_100M 0x2
+#define PHYCTRL_FREQSEL_150M 0x3
+#define PHYCTRL_FREQSEL_MASK 0x3
+#define PHYCTRL_FREQSEL_SHIFT 0xc
+#define PHYCTRL_DR_MASK 0x7
+#define PHYCTRL_DR_SHIFT 0x4
+#define PHYCTRL_DR_50OHM 0x0
+#define PHYCTRL_DR_33OHM 0x1
+#define PHYCTRL_DR_66OHM 0x2
+#define PHYCTRL_DR_100OHM 0x3
+#define PHYCTRL_DR_40OHM 0x4
struct rockchip_emmc_phy {
unsigned int reg_offset;
@@ -154,6 +167,20 @@
struct rockchip_emmc_phy *rk_phy = phy_get_drvdata(phy);
int ret = 0;
+ /* DLL operation: 200 MHz */
+ regmap_write(rk_phy->reg_base,
+ rk_phy->reg_offset + GRF_EMMCPHY_CON0,
+ HIWORD_UPDATE(PHYCTRL_FREQSEL_200M,
+ PHYCTRL_FREQSEL_MASK,
+ PHYCTRL_FREQSEL_SHIFT));
+
+ /* Drive impedance: 50 Ohm */
+ regmap_write(rk_phy->reg_base,
+ rk_phy->reg_offset + GRF_EMMCPHY_CON6,
+ HIWORD_UPDATE(PHYCTRL_DR_50OHM,
+ PHYCTRL_DR_MASK,
+ PHYCTRL_DR_SHIFT));
+
/* Power up emmc phy analog blocks */
ret = rockchip_emmc_phy_power(rk_phy, PHYCTRL_PDB_PWR_ON);
if (ret)