be2net: Fix VLAN promiscuous mode programming
When the interface runs out of the allocated entries in VLAN table,
we program the interface in VLAN promiscuous mode.
Use OPCODE_COMMON_NTWK_RX_FILTER to set VLAN Promiscuous mode
instead of OPCODE_COMMON_NTWK_VLAN_CONFIG.
Signed-off-by: Ajit Khaparde <ajit.khaparde@emulex.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/emulex/benet/be.h b/drivers/net/ethernet/emulex/benet/be.h
index ace5050..95d303d 100644
--- a/drivers/net/ethernet/emulex/benet/be.h
+++ b/drivers/net/ethernet/emulex/benet/be.h
@@ -333,6 +333,7 @@
#define BE_FLAGS_LINK_STATUS_INIT 1
#define BE_FLAGS_WORKER_SCHEDULED (1 << 3)
+#define BE_FLAGS_VLAN_PROMISC (1 << 4)
#define BE_FLAGS_NAPI_ENABLED (1 << 9)
#define BE_UC_PMAC_COUNT 30
#define BE_VF_UC_PMAC_COUNT 2