tree 492a20db7dea81485f18da313a50e1a4136a9575
parent f477b7fb13df2b843997559ff34e87d054ba6538
author Sourav Poddar <sourav.poddar@ti.com> 1377186648 +0530
committer Mark Brown <broonie@linaro.org> 1377194739 +0100

spi: conditional checking of mode and transfer bits.

There is a bug in the following patch:
http://comments.gmane.org/gmane.linux.kernel.spi.devel/14420

spi: DUAL and QUAD support

    fix the previous patch some mistake below:
    1. DT in slave node, use "spi-tx-nbits = <1/2/4>" in place of using
       "spi-tx-dual, spi-tx-quad" directly, same to rx. So correct the
       previous way to get the property in @of_register_spi_devices().
    2. Change the value of transfer bit macro(SPI_NBITS_SINGLE, SPI_NBITS_DUAL
       SPI_NBITS_QUAD) to 0x01, 0x02 and 0x04 to match the actual wires.
    3. Add the following check
       (1)keep the tx_nbits and rx_nbits in spi_transfer is not beyond the
          single, dual and quad.
       (2)keep tx_nbits and rx_nbits are contained by @spi_device->mode
          example: if @spi_device->mode = DUAL, then tx/rx_nbits can not be set
                   to QUAD(SPI_NBITS_QUAD)
       (3)if "@spi_device->mode & SPI_3WIRE", then tx/rx_nbits should be in
          single(SPI_NBITS_SINGLE)

Checking of the tx/rx transfer bits and mode bits should be done conditionally
based on type of buffer filled else EINVAL condition will
always get hit either for rx or tx.

Signed-off-by: Sourav Poddar <sourav.poddar@ti.com>
Signed-off-by: Mark Brown <broonie@linaro.org>