bnx2x: VF fastpath
When VF driver is transmitting it must supply the correct mac
address in the parsing BD. This is used for firmware validation
and enforcement and also for tx-switching.
Refactor interrupt ack flow to allow for different BAR addresses of
the hardware in the PF BAR vs the VF BAR.
Signed-off-by: Ariel Elior <ariele@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c
index 362451d..18baf75 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c
@@ -3472,8 +3472,18 @@
cpu_to_le16(vlan_tx_tag_get(skb));
tx_start_bd->bd_flags.as_bitfield |=
(X_ETH_OUTBAND_VLAN << ETH_TX_BD_FLAGS_VLAN_MODE_SHIFT);
- } else
- tx_start_bd->vlan_or_ethertype = cpu_to_le16(pkt_prod);
+ } else {
+ /* when transmitting in a vf, start bd must hold the ethertype
+ * for fw to enforce it
+ */
+ if (IS_VF(bp)) {
+ tx_start_bd->vlan_or_ethertype =
+ cpu_to_le16(ntohs(eth->h_proto));
+ } else {
+ /* used by FW for packet accounting */
+ tx_start_bd->vlan_or_ethertype = cpu_to_le16(pkt_prod);
+ }
+ }
/* turn on parsing and get a BD */
bd_prod = TX_BD(NEXT_TX_IDX(bd_prod));
@@ -3489,9 +3499,9 @@
hlen = bnx2x_set_pbd_csum_e2(bp, skb,
&pbd_e2_parsing_data,
xmit_type);
- if (IS_MF_SI(bp)) {
- /*
- * fill in the MAC addresses in the PBD - for local
+
+ if (IS_MF_SI(bp) || IS_VF(bp)) {
+ /* fill in the MAC addresses in the PBD - for local
* switching
*/
bnx2x_set_fw_mac_addr(&pbd_e2->src_mac_addr_hi,