clk: bcm281xx: add clock hysteresis support
Add support for clock gate hysteresis control. For now, if it's
defined for a clock, it's enabled.
Signed-off-by: Alex Elder <elder@linaro.org>
Signed-off-by: Mike Turquette <mturquette@linaro.org>
diff --git a/drivers/clk/bcm/clk-kona.h b/drivers/clk/bcm/clk-kona.h
index 4bcba13..2537b30 100644
--- a/drivers/clk/bcm/clk-kona.h
+++ b/drivers/clk/bcm/clk-kona.h
@@ -60,6 +60,8 @@
#define gate_flip_enabled(gate) FLAG_FLIP(gate, GATE, ENABLED)
+#define hyst_exists(hyst) ((hyst)->offset != 0)
+
#define divider_exists(div) FLAG_TEST(div, DIV, EXISTS)
#define divider_is_fixed(div) FLAG_TEST(div, DIV, FIXED)
#define divider_has_fraction(div) (!divider_is_fixed(div) && \
@@ -205,6 +207,22 @@
.flags = FLAG(GATE, HW)|FLAG(GATE, EXISTS), \
}
+/* Gate hysteresis for clocks */
+struct bcm_clk_hyst {
+ u32 offset; /* hyst register offset (normally CLKGATE) */
+ u32 en_bit; /* bit used to enable hysteresis */
+ u32 val_bit; /* if enabled: 0 = low delay; 1 = high delay */
+};
+
+/* Hysteresis initialization macro */
+
+#define HYST(_offset, _en_bit, _val_bit) \
+ { \
+ .offset = (_offset), \
+ .en_bit = (_en_bit), \
+ .val_bit = (_val_bit), \
+ }
+
/*
* Each clock can have zero, one, or two dividers which change the
* output rate of the clock. Each divider can be either fixed or
@@ -372,6 +390,7 @@
struct peri_clk_data {
struct bcm_clk_policy policy;
struct bcm_clk_gate gate;
+ struct bcm_clk_hyst hyst;
struct bcm_clk_trig pre_trig;
struct bcm_clk_div pre_div;
struct bcm_clk_trig trig;