au1000-eth: change multi-line comments style
Signed-off-by: Florian Fainelli <florian@openwrt.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/au1000_eth.c b/drivers/net/au1000_eth.c
index f4c394f..43489f8 100644
--- a/drivers/net/au1000_eth.c
+++ b/drivers/net/au1000_eth.c
@@ -229,11 +229,15 @@
static int au1000_mdiobus_read(struct mii_bus *bus, int phy_addr, int regnum)
{
/* WARNING: bus->phy_map[phy_addr].attached_dev == dev does
- * _NOT_ hold (e.g. when PHY is accessed through other MAC's MII bus) */
+ * _NOT_ hold (e.g. when PHY is accessed through other MAC's MII bus)
+ */
struct net_device *const dev = bus->priv;
- au1000_enable_mac(dev, 0); /* make sure the MAC associated with this
- * mii_bus is enabled */
+ /* make sure the MAC associated with this
+ * mii_bus is enabled
+ */
+ au1000_enable_mac(dev, 0);
+
return au1000_mdio_read(dev, phy_addr, regnum);
}
@@ -242,8 +246,11 @@
{
struct net_device *const dev = bus->priv;
- au1000_enable_mac(dev, 0); /* make sure the MAC associated with this
- * mii_bus is enabled */
+ /* make sure the MAC associated with this
+ * mii_bus is enabled
+ */
+ au1000_enable_mac(dev, 0);
+
au1000_mdio_write(dev, phy_addr, regnum, value);
return 0;
}
@@ -252,8 +259,11 @@
{
struct net_device *const dev = bus->priv;
- au1000_enable_mac(dev, 0); /* make sure the MAC associated with this
- * mii_bus is enabled */
+ /* make sure the MAC associated with this
+ * mii_bus is enabled
+ */
+ au1000_enable_mac(dev, 0);
+
return 0;
}
@@ -380,7 +390,8 @@
}
/* find the first (lowest address) PHY
- * on the current MAC's MII bus */
+ * on the current MAC's MII bus
+ */
for (phy_addr = 0; phy_addr < PHY_MAX_ADDR; phy_addr++)
if (aup->mii_bus->phy_map[phy_addr]) {
phydev = aup->mii_bus->phy_map[phy_addr];
@@ -774,7 +785,8 @@
if (!aup->phy_dev || (DUPLEX_FULL == aup->phy_dev->duplex)) {
if (status & (TX_JAB_TIMEOUT | TX_UNDERRUN)) {
/* any other tx errors are only valid
- * in half duplex mode */
+ * in half duplex mode
+ */
ps->tx_errors++;
ps->tx_aborted_errors++;
}
@@ -1068,8 +1080,9 @@
aup->msg_enable = (au1000_debug < 4 ?
AU1000_DEF_MSG_ENABLE : au1000_debug);
- /* Allocate the data buffers */
- /* Snooping works fine with eth on all au1xxx */
+ /* Allocate the data buffers
+ * Snooping works fine with eth on all au1xxx
+ */
aup->vaddr = (u32)dma_alloc_noncoherent(NULL, MAX_BUF_SIZE *
(NUM_TX_BUFFS + NUM_RX_BUFFS),
&aup->dma_addr, 0);
@@ -1226,7 +1239,8 @@
mdiobus_unregister(aup->mii_bus);
/* here we should have a valid dev plus aup-> register addresses
- * so we can reset the mac properly.*/
+ * so we can reset the mac properly.
+ */
au1000_reset_mac(dev);
for (i = 0; i < NUM_RX_DMA; i++) {
diff --git a/drivers/net/au1000_eth.h b/drivers/net/au1000_eth.h
index 4b638df2..6229c77 100644
--- a/drivers/net/au1000_eth.h
+++ b/drivers/net/au1000_eth.h
@@ -100,7 +100,8 @@
int mac_id;
int mac_enabled; /* whether MAC is currently enabled and running
- (req. for mdio) */
+ * (req. for mdio)
+ */
int old_link; /* used by au1000_adjust_link */
int old_speed;
@@ -119,7 +120,8 @@
int phy_irq;
/* These variables are just for quick access
- * to certain regs addresses. */
+ * to certain regs addresses.
+ */
struct mac_reg *mac; /* mac registers */
u32 *enable; /* address of MAC Enable Register */