firmware: arm_scpi: fix send_message and sensor_get_value for big-endian
scpi_process_cmd converts the status word from little endian to cpu
endianness. However scpi_send_message again does the conversion which is
wrong and shows up as a bug only when running in big-endian kernel.
Similarly scpi_sensor_get_value passes the sensor index in the cpu
endianness to SCP which results in SCPI_ERR_RANGE in big-endian mode.
This patch fixes the above mentioned issue for big-endian kernel.
Acked-by: Punit Agrawal <punit.agrawal@arm.com>
Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>
diff --git a/drivers/firmware/arm_scpi.c b/drivers/firmware/arm_scpi.c
index 6174db8..3cb591e 100644
--- a/drivers/firmware/arm_scpi.c
+++ b/drivers/firmware/arm_scpi.c
@@ -373,7 +373,7 @@
ret = -ETIMEDOUT;
else
/* first status word */
- ret = le32_to_cpu(msg->status);
+ ret = msg->status;
out:
if (ret < 0 && rx_buf) /* remove entry from the list if timed-out */
scpi_process_cmd(scpi_chan, msg->cmd);
@@ -527,10 +527,11 @@
int scpi_sensor_get_value(u16 sensor, u32 *val)
{
+ __le16 id = cpu_to_le16(sensor);
struct sensor_value buf;
int ret;
- ret = scpi_send_message(SCPI_CMD_SENSOR_VALUE, &sensor, sizeof(sensor),
+ ret = scpi_send_message(SCPI_CMD_SENSOR_VALUE, &id, sizeof(id),
&buf, sizeof(buf));
if (!ret)
*val = le32_to_cpu(buf.val);