mac80211: split out and decrease probe wait time
The time we wait for a probe response after probing an AP due to
beacon loss is currently the same as the monitoring interval, 2s.
This is far too long, APs should respond to probes within a
fraction of that time. To be able to adjust both values, add a
new constant IEEE80211_PROBE_WAIT, use it for checking the probe
response, and adjust it down to 200ms instead of 2 seconds.
Signed-off-by: Johannes Berg <johannes@sipsolutions.net>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/net/mac80211/mlme.c b/net/mac80211/mlme.c
index 7835e7d..ae03068 100644
--- a/net/mac80211/mlme.c
+++ b/net/mac80211/mlme.c
@@ -33,6 +33,7 @@
#define IEEE80211_ASSOC_TIMEOUT (HZ / 5)
#define IEEE80211_ASSOC_MAX_TRIES 3
#define IEEE80211_MONITORING_INTERVAL (2 * HZ)
+#define IEEE80211_PROBE_WAIT (HZ / 20)
#define IEEE80211_PROBE_IDLE_TIME (60 * HZ)
#define IEEE80211_RETRY_AUTH_INTERVAL (1 * HZ)
@@ -1205,7 +1206,7 @@
ieee80211_send_probe_req(sdata, ifmgd->bssid, ifmgd->ssid,
ifmgd->ssid_len, NULL, 0);
- mod_timer(&ifmgd->timer, jiffies + IEEE80211_MONITORING_INTERVAL);
+ mod_timer(&ifmgd->timer, jiffies + IEEE80211_PROBE_WAIT);
}
void ieee80211_beacon_loss(struct ieee80211_vif *vif)
@@ -1242,7 +1243,7 @@
}
if ((ifmgd->flags & IEEE80211_STA_PROBEREQ_POLL) &&
- time_after(jiffies, sta->last_rx + IEEE80211_MONITORING_INTERVAL)) {
+ time_after(jiffies, sta->last_rx + IEEE80211_PROBE_WAIT)) {
printk(KERN_DEBUG "%s: no probe response from AP %pM "
"- disassociating\n",
sdata->dev->name, ifmgd->bssid);