nilfs2: add missing blkdev_issue_flush() to nilfs_sync_fs()
Under normal circumstances nilfs_sync_fs() writes out the super block,
which causes a flush of the underlying block device. But this depends
on the THE_NILFS_SB_DIRTY flag, which is only set if the pointer to the
last segment crosses a segment boundary. So if only a small amount of
data is written before the call to nilfs_sync_fs(), no flush of the
block device occurs.
In the above case an additional call to blkdev_issue_flush() is needed.
To prevent unnecessary overhead, the new flag nilfs->ns_flushed_device
is introduced, which is cleared whenever new logs are written and set
whenever the block device is flushed. For convenience the function
nilfs_flush_device() is added, which contains the above logic.
Signed-off-by: Andreas Rohner <andreas.rohner@gmx.net>
Signed-off-by: Ryusuke Konishi <konishi.ryusuke@lab.ntt.co.jp>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/fs/nilfs2/segment.c b/fs/nilfs2/segment.c
index a1a1916..0b7d2ca 100644
--- a/fs/nilfs2/segment.c
+++ b/fs/nilfs2/segment.c
@@ -1833,6 +1833,7 @@
nilfs_set_next_segment(nilfs, segbuf);
if (update_sr) {
+ nilfs->ns_flushed_device = 0;
nilfs_set_last_segment(nilfs, segbuf->sb_pseg_start,
segbuf->sb_sum.seg_seq, nilfs->ns_cno++);
@@ -2216,6 +2217,8 @@
sci->sc_dsync_end = end;
err = nilfs_segctor_do_construct(sci, SC_LSEG_DSYNC);
+ if (!err)
+ nilfs->ns_flushed_device = 0;
nilfs_transaction_unlock(sb);
return err;