libata: skip EH autopsy and recovery during suspend
For some mysterious reason, certain hardware reacts badly to usual EH
actions while the system is going for suspend. As the devices won't
be needed until the system is resumed, ask EH to skip usual autopsy
and recovery and proceed directly to suspend.
Signed-off-by: Tejun Heo <tj@kernel.org>
Tested-by: Stephan Diestelhorst <stephan.diestelhorst@amd.com>
Cc: stable@kernel.org
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
diff --git a/drivers/ata/libata-core.c b/drivers/ata/libata-core.c
index c035b3d..932eaee 100644
--- a/drivers/ata/libata-core.c
+++ b/drivers/ata/libata-core.c
@@ -5418,6 +5418,7 @@
*/
int ata_host_suspend(struct ata_host *host, pm_message_t mesg)
{
+ unsigned int ehi_flags = ATA_EHI_QUIET;
int rc;
/*
@@ -5426,7 +5427,18 @@
*/
ata_lpm_enable(host);
- rc = ata_host_request_pm(host, mesg, 0, ATA_EHI_QUIET, 1);
+ /*
+ * On some hardware, device fails to respond after spun down
+ * for suspend. As the device won't be used before being
+ * resumed, we don't need to touch the device. Ask EH to skip
+ * the usual stuff and proceed directly to suspend.
+ *
+ * http://thread.gmane.org/gmane.linux.ide/46764
+ */
+ if (mesg.event == PM_EVENT_SUSPEND)
+ ehi_flags |= ATA_EHI_NO_AUTOPSY | ATA_EHI_NO_RECOVERY;
+
+ rc = ata_host_request_pm(host, mesg, 0, ehi_flags, 1);
if (rc == 0)
host->dev->power.power_state = mesg;
return rc;