ALSA: Don't cold reset AC97 codecs in some ICH chipsets
Check in a quirk list if it should do cold reset when AC97 power saving
is enabled. Some devices do not resume properly when cold reset,
although power saving works OK.
Signed-off-by: Thadeu Lima de Souza Cascardo <cascardo@holoscopio.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
diff --git a/sound/pci/intel8x0.c b/sound/pci/intel8x0.c
index 19d3391..b37bd26 100644
--- a/sound/pci/intel8x0.c
+++ b/sound/pci/intel8x0.c
@@ -2287,23 +2287,23 @@
iputdword(chip, ICHREG(ALI_INTERRUPTSR), 0x00000000);
}
-static int snd_intel8x0_ich_chip_init(struct intel8x0 *chip, int probing)
-{
- unsigned long end_time;
- unsigned int cnt, status, nstatus;
-
- /* put logic to right state */
- /* first clear status bits */
- status = ICH_RCS | ICH_MCINT | ICH_POINT | ICH_PIINT;
- if (chip->device_type == DEVICE_NFORCE)
- status |= ICH_NVSPINT;
- cnt = igetdword(chip, ICHREG(GLOB_STA));
- iputdword(chip, ICHREG(GLOB_STA), cnt & status);
+#ifdef CONFIG_SND_AC97_POWER_SAVE
+static struct snd_pci_quirk ich_chip_reset_mode[] = {
+ SND_PCI_QUIRK(0x1014, 0x051f, "Thinkpad R32", 1),
+ { } /* end */
+};
+static int snd_intel8x0_ich_chip_cold_reset(struct intel8x0 *chip)
+{
+ unsigned int cnt;
/* ACLink on, 2 channels */
+
+ if (snd_pci_quirk_lookup(chip->pci, ich_chip_reset_mode))
+ return -EIO;
+
cnt = igetdword(chip, ICHREG(GLOB_CNT));
cnt &= ~(ICH_ACLINK | ICH_PCM_246_MASK);
-#ifdef CONFIG_SND_AC97_POWER_SAVE
+
/* do cold reset - the full ac97 powerdown may leave the controller
* in a warm state but actually it cannot communicate with the codec.
*/
@@ -2312,22 +2312,58 @@
udelay(10);
iputdword(chip, ICHREG(GLOB_CNT), cnt | ICH_AC97COLD);
msleep(1);
+ return 0;
+}
+#define snd_intel8x0_ich_chip_can_cold_reset(chip) \
+ (!snd_pci_quirk_lookup(chip->pci, ich_chip_reset_mode))
#else
+#define snd_intel8x0_ich_chip_cold_reset(x) do { } while (0)
+#define snd_intel8x0_ich_chip_can_cold_reset(chip) (0)
+#endif
+
+static int snd_intel8x0_ich_chip_reset(struct intel8x0 *chip)
+{
+ unsigned long end_time;
+ unsigned int cnt;
+ /* ACLink on, 2 channels */
+ cnt = igetdword(chip, ICHREG(GLOB_CNT));
+ cnt &= ~(ICH_ACLINK | ICH_PCM_246_MASK);
/* finish cold or do warm reset */
cnt |= (cnt & ICH_AC97COLD) == 0 ? ICH_AC97COLD : ICH_AC97WARM;
iputdword(chip, ICHREG(GLOB_CNT), cnt);
end_time = (jiffies + (HZ / 4)) + 1;
do {
if ((igetdword(chip, ICHREG(GLOB_CNT)) & ICH_AC97WARM) == 0)
- goto __ok;
+ return 0;
schedule_timeout_uninterruptible(1);
} while (time_after_eq(end_time, jiffies));
snd_printk(KERN_ERR "AC'97 warm reset still in progress? [0x%x]\n",
igetdword(chip, ICHREG(GLOB_CNT)));
return -EIO;
+}
- __ok:
-#endif
+static int snd_intel8x0_ich_chip_init(struct intel8x0 *chip, int probing)
+{
+ unsigned long end_time;
+ unsigned int status, nstatus;
+ unsigned int cnt;
+ int err;
+
+ /* put logic to right state */
+ /* first clear status bits */
+ status = ICH_RCS | ICH_MCINT | ICH_POINT | ICH_PIINT;
+ if (chip->device_type == DEVICE_NFORCE)
+ status |= ICH_NVSPINT;
+ cnt = igetdword(chip, ICHREG(GLOB_STA));
+ iputdword(chip, ICHREG(GLOB_STA), cnt & status);
+
+ if (snd_intel8x0_ich_chip_can_cold_reset(chip))
+ err = snd_intel8x0_ich_chip_cold_reset(chip);
+ else
+ err = snd_intel8x0_ich_chip_reset(chip);
+ if (err < 0)
+ return err;
+
if (probing) {
/* wait for any codec ready status.
* Once it becomes ready it should remain ready