mx25: fix clock's calculation
* get_rate_arm : when 400MHz clock is selected (cctl & 1<<14),
ARM clock is 400MHz (MPLL * 3 / 4) and not 800MHz
* get_rate_per : peripherals's clock is derived from AHB and not
from IPG (ref manual : figure 5-1)
* can2_clk : use the correct ID
* without this patch, peripherals getting their clock from PER
clocks work fine because of the 2 errors which fix themselves
(ARM clock x 2 and per clock actually based on IPG which is AHB/2)
but flexcan can't work as it gets its clock from IPG and thus
calculates its bitrate using a reference value which is twice
what it really is.
Signed-off-by: Eric Bénard <eric@eukrea.com>
diff --git a/arch/arm/mach-mx25/clock.c b/arch/arm/mach-mx25/clock.c
index 2179713..9e4a557 100644
--- a/arch/arm/mach-mx25/clock.c
+++ b/arch/arm/mach-mx25/clock.c
@@ -72,7 +72,7 @@
unsigned long rate = get_rate_mpll();
if (cctl & (1 << 14))
- rate = (rate * 3) >> 1;
+ rate = (rate * 3) >> 2;
return rate / ((cctl >> 30) + 1);
}
@@ -99,7 +99,7 @@
if (readl(CRM_BASE + 0x64) & (1 << per))
fref = get_rate_upll();
else
- fref = get_rate_ipg(NULL);
+ fref = get_rate_ahb(NULL);
return fref / (val + 1);
}
@@ -261,7 +261,7 @@
DEFINE_CLOCK(audmux_clk, 0, CCM_CGCR1, 0, NULL, NULL, NULL);
DEFINE_CLOCK(csi_clk, 0, CCM_CGCR1, 4, get_rate_csi, NULL, &csi_per_clk);
DEFINE_CLOCK(can1_clk, 0, CCM_CGCR1, 2, get_rate_ipg, NULL, NULL);
-DEFINE_CLOCK(can2_clk, 0, CCM_CGCR1, 3, get_rate_ipg, NULL, NULL);
+DEFINE_CLOCK(can2_clk, 1, CCM_CGCR1, 3, get_rate_ipg, NULL, NULL);
#define _REGISTER_CLOCK(d, n, c) \
{ \