pwm: lpss: Fix base_unit calculation for PWM frequency
The base_unit calculation applies an offset of 0x2 which adds
significant error for lower frequencies and doesn't appear to be
warranted - rounding the division result gives a correct value.
Also, the upper limit check for base_unit is off-by-one; the upper
nibble of base_unit is invalid if >=128 according to the Table 88
in the Z8000 Processor Series Datasheet Volume 1 (Rev. 2).
Verified on UP Board (Cherry Trail) and Minnowboard Max (Bay Trail).
Signed-off-by: Dan O'Donovan <dan@emutex.com>
Acked-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Thierry Reding <thierry.reding@gmail.com>
diff --git a/drivers/pwm/pwm-lpss.c b/drivers/pwm/pwm-lpss.c
index 295b963..98dc8b8 100644
--- a/drivers/pwm/pwm-lpss.c
+++ b/drivers/pwm/pwm-lpss.c
@@ -27,7 +27,6 @@
#define PWM_SW_UPDATE BIT(30)
#define PWM_BASE_UNIT_SHIFT 8
#define PWM_ON_TIME_DIV_MASK 0x000000ff
-#define PWM_DIVISION_CORRECTION 0x2
/* Size of each PWM register space if multiple */
#define PWM_SIZE 0x400
@@ -101,17 +100,16 @@
/*
* The equation is:
- * base_unit = ((freq / c) * base_unit_range) + correction
+ * base_unit = round(base_unit_range * freq / c)
*/
base_unit_range = BIT(lpwm->info->base_unit_bits);
- base_unit = freq * base_unit_range;
+ freq *= base_unit_range;
c = lpwm->info->clk_rate;
if (!c)
return -EINVAL;
- do_div(base_unit, c);
- base_unit += PWM_DIVISION_CORRECTION;
+ base_unit = DIV_ROUND_CLOSEST_ULL(freq, c);
if (duty_ns <= 0)
duty_ns = 1;