[PATCH] yenta: make ToPIC95 bridges work with 16bit cards
ToPIC95 brides (and maybe some other too) require to use the ExCA registers
to power up the socket if a 16bit card is pluged. allow socket drivers to
set a flag so that yenta does just that. also clean up yenta_get_status()
a bit to use the new yenta_get_power() function.
Side note: ToPIC97 bridges (at least in Rev.5 i have) don't require this.
Ryan Underwood <nemesis-lists@icequake.net> said:
According to the mail that David Hinds received from a Toshiba engineer,
ToPIC95 and 97 do require this, and ToPIC100 does not. Maybe you have a
later revision.
For all chips, 16-bit cards can be enabled through ExCA. So doesn't it
make sense just to make this the default behavior for all Toshiba chips,
to avoid corner cases showing up later?
Daniel responded:
I disagree with ryan to change anything for topic97 bridges. they work.
and I couldn't find (read google) any report of a topic97 breaking on
applying power with the CB registers.
I'm having several toshba notebooks at work (and home) with topic95,97,100
bridges. Only the ones with a topic95 didn't work.
Signed-off-by: Daniel Ritz <daniel.ritz@gmx.ch>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/pcmcia/yenta_socket.h b/drivers/pcmcia/yenta_socket.h
index 4e637ee..4e75e9e 100644
--- a/drivers/pcmcia/yenta_socket.h
+++ b/drivers/pcmcia/yenta_socket.h
@@ -95,6 +95,12 @@
*/
#define CB_MEM_PAGE(map) (0x40 + (map))
+
+/* control how 16bit cards are powered */
+#define YENTA_16BIT_POWER_EXCA 0x00000001
+#define YENTA_16BIT_POWER_DF 0x00000002
+
+
struct yenta_socket;
struct cardbus_type {
@@ -113,6 +119,8 @@
struct pcmcia_socket socket;
struct cardbus_type *type;
+ u32 flags;
+
/* for PCI interrupt probing */
unsigned int probe_status;