qla2xxx: Add Dual mode support in the driver
Add switch to allow both Initiator Mode & Target
mode to operate at the same time.
Signed-off-by: Quinn Tran <quinn.tran@cavium.com>
Signed-off-by: Himanshu Madhani <himanshu.madhani@cavium.com>
Signed-off-by: Bart Van Assche <bart.vanassche@sandisk.com>
Signed-off-by: Nicholas Bellinger <nab@linux-iscsi.org>
diff --git a/drivers/scsi/qla2xxx/qla_init.c b/drivers/scsi/qla2xxx/qla_init.c
index 8b7c046..4c0a2d8 100644
--- a/drivers/scsi/qla2xxx/qla_init.c
+++ b/drivers/scsi/qla2xxx/qla_init.c
@@ -1568,8 +1568,7 @@
}
}
- if (qla_ini_mode_enabled(vha) ||
- qla_dual_mode_enabled(vha))
+ if (qla_ini_mode_enabled(vha) || qla_dual_mode_enabled(vha))
rval = qla2x00_init_rings(vha);
ha->flags.chip_reset_done = 1;
@@ -3994,7 +3993,8 @@
* Process any ATIO queue entries that came in
* while we weren't online.
*/
- if (qla_tgt_mode_enabled(vha)) {
+ if (qla_tgt_mode_enabled(vha) ||
+ qla_dual_mode_enabled(vha)) {
if (IS_QLA27XX(ha) || IS_QLA83XX(ha)) {
spin_lock_irqsave(&ha->tgt.atio_lock,
flags);