dmaengine: edma: DT: Change memcpy channel array from 16bit to 32bit type
This change makes the DT file to be easier to read since the memcpy
channels array does not need the '/bits/ 16' to be specified, which might
confuse some people.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Acked-by: Rob Herring <robh@kernel.org>
Acked-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Vinod Koul <vinod.koul@intel.com>
diff --git a/Documentation/devicetree/bindings/dma/ti-edma.txt b/Documentation/devicetree/bindings/dma/ti-edma.txt
index d3d0a4f..ae8b8f1 100644
--- a/Documentation/devicetree/bindings/dma/ti-edma.txt
+++ b/Documentation/devicetree/bindings/dma/ti-edma.txt
@@ -22,8 +22,7 @@
Optional properties:
- ti,hwmods: Name of the hwmods associated to the eDMA CC
- ti,edma-memcpy-channels: List of channels allocated to be used for memcpy, iow
- these channels will be SW triggered channels. The list must
- contain 16 bits numbers, see example.
+ these channels will be SW triggered channels. See example.
- ti,edma-reserved-slot-ranges: PaRAM slot ranges which should not be used by
the driver, they are allocated to be used by for example the
DSP. See example.
@@ -56,7 +55,7 @@
ti,tptcs = <&edma_tptc0 7>, <&edma_tptc1 7>, <&edma_tptc2 0>;
/* Channel 20 and 21 is allocated for memcpy */
- ti,edma-memcpy-channels = /bits/ 16 <20 21>;
+ ti,edma-memcpy-channels = <20 21>;
/* The following PaRAM slots are reserved: 35-45 and 100-110 */
ti,edma-reserved-slot-ranges = /bits/ 16 <35 10>,
/bits/ 16 <100 10>;