avr32: Provide a way to deselect pins in the portmux
Currently, setting up the portmux is completely one-shot: Once a pin is
muxed, the portmux driver will complain loudly and refuse to do anything
if you try to set up the same pin again.
Sometimes, it may be necessary to change the configuration of a pin
after it has been set up initially. This patch adds a way to undo the
previous configuration, allowing the pin to be reconfigured.
Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
diff --git a/arch/avr32/mach-at32ap/pio.c b/arch/avr32/mach-at32ap/pio.c
index 405ee6b..90ef538 100644
--- a/arch/avr32/mach-at32ap/pio.c
+++ b/arch/avr32/mach-at32ap/pio.c
@@ -134,6 +134,25 @@
dump_stack();
}
+/*
+ * Undo a previous pin reservation. Will not affect the hardware
+ * configuration.
+ */
+void at32_deselect_pin(unsigned int pin)
+{
+ struct pio_device *pio;
+ unsigned int pin_index = pin & 0x1f;
+
+ pio = gpio_to_pio(pin);
+ if (unlikely(!pio)) {
+ printk("pio: invalid pin %u\n", pin);
+ dump_stack();
+ return;
+ }
+
+ clear_bit(pin_index, &pio->pinmux_mask);
+}
+
/* Reserve a pin, preventing anyone else from changing its configuration. */
void __init at32_reserve_pin(unsigned int pin)
{