powerpc: Remove all usages of NO_IRQ
NO_IRQ has been == 0 on powerpc for just over ten years (since commit
0ebfff1491ef ("[POWERPC] Add new interrupt mapping core and change
platforms to use it")). It's also 0 on most other arches.
Although it's fairly harmless, every now and then it causes confusion
when a driver is built on powerpc and another arch which doesn't define
NO_IRQ. There's at least 6 definitions of NO_IRQ in drivers/, at least
some of which are to work around that problem.
So we'd like to remove it. This is fairly trivial in the arch code, we
just convert:
if (irq == NO_IRQ) to if (!irq)
if (irq != NO_IRQ) to if (irq)
irq = NO_IRQ; to irq = 0;
return NO_IRQ; to return 0;
And a few other odd cases as well.
At least for now we keep the #define NO_IRQ, because there is driver
code that uses NO_IRQ and the fixes to remove those will go via other
trees.
Note we also change some occurrences in PPC sound drivers, drivers/ps3,
and drivers/macintosh.
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>
diff --git a/arch/powerpc/platforms/pseries/setup.c b/arch/powerpc/platforms/pseries/setup.c
index 4ffcaa6..7769000 100644
--- a/arch/powerpc/platforms/pseries/setup.c
+++ b/arch/powerpc/platforms/pseries/setup.c
@@ -114,7 +114,7 @@
struct irq_chip *chip = irq_desc_get_chip(desc);
unsigned int cascade_irq = i8259_irq();
- if (cascade_irq != NO_IRQ)
+ if (cascade_irq)
generic_handle_irq(cascade_irq);
chip->irq_eoi(&desc->irq_data);
@@ -141,7 +141,7 @@
}
cascade = irq_of_parse_and_map(found, 0);
- if (cascade == NO_IRQ) {
+ if (!cascade) {
printk(KERN_ERR "pic: failed to map cascade interrupt");
return;
}