usb: allow to supply the PHY in the drivers when using HCD
This patch modify the generic code handling PHYs to allow them to be
supplied from the drivers. This adds checks to ensure no PHY was already
there when looking for one in the generic code. This also makes sure we
do not modify its state in the generic HCD functions, it was provided by
the driver.
Signed-off-by: Antoine Tenart <antoine.tenart@free-electrons.com>
Acked-by: Alan Stern <stern@rowland.harvard.edu>
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/drivers/usb/chipidea/ci_hdrc_msm.c b/drivers/usb/chipidea/ci_hdrc_msm.c
index 4935ac3..3edf969 100644
--- a/drivers/usb/chipidea/ci_hdrc_msm.c
+++ b/drivers/usb/chipidea/ci_hdrc_msm.c
@@ -26,15 +26,15 @@
dev_dbg(dev, "CI_HDRC_CONTROLLER_RESET_EVENT received\n");
writel(0, USB_AHBBURST);
writel(0, USB_AHBMODE);
- usb_phy_init(ci->transceiver);
+ usb_phy_init(ci->usb_phy);
break;
case CI_HDRC_CONTROLLER_STOPPED_EVENT:
dev_dbg(dev, "CI_HDRC_CONTROLLER_STOPPED_EVENT received\n");
/*
- * Put the transceiver in non-driving mode. Otherwise host
+ * Put the phy in non-driving mode. Otherwise host
* may not detect soft-disconnection.
*/
- usb_phy_notify_disconnect(ci->transceiver, USB_SPEED_UNKNOWN);
+ usb_phy_notify_disconnect(ci->usb_phy, USB_SPEED_UNKNOWN);
break;
default:
dev_dbg(dev, "unknown ci_hdrc event\n");
@@ -68,7 +68,7 @@
if (IS_ERR(phy))
return PTR_ERR(phy);
- ci_hdrc_msm_platdata.phy = phy;
+ ci_hdrc_msm_platdata.usb_phy = phy;
plat_ci = ci_hdrc_add_device(&pdev->dev,
pdev->resource, pdev->num_resources,