MFD: ti_tscadc: ADC Clock check not required
ADC is ideally expected to work at a frequency of 3MHz.
The present code had a check, which returned error if the frequency
went below the threshold value. But since AM335x supports various
working frequencies, this check is not required.
Now the code just uses the internal ADC clock divider to set the ADC
frequency w.r.t the sys clock.
Signed-off-by: Patil, Rachna <rachna@ti.com>
Signed-off-by: Zubair Lutfullah <zubair.lutfullah@gmail.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>
Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
diff --git a/drivers/mfd/ti_am335x_tscadc.c b/drivers/mfd/ti_am335x_tscadc.c
index b003a16..e0852ec 100644
--- a/drivers/mfd/ti_am335x_tscadc.c
+++ b/drivers/mfd/ti_am335x_tscadc.c
@@ -197,11 +197,7 @@
clock_rate = clk_get_rate(clk);
clk_put(clk);
clk_value = clock_rate / ADC_CLK;
- if (clk_value < MAX_CLK_DIV) {
- dev_err(&pdev->dev, "clock input less than min clock requirement\n");
- err = -EINVAL;
- goto err_disable_clk;
- }
+
/* TSCADC_CLKDIV needs to be configured to the value minus 1 */
clk_value = clk_value - 1;
tscadc_writel(tscadc, REG_CLKDIV, clk_value);