usb: musb: set AUTOSET for full speed bulk DMA transfer in host mode
The "mult" factor is not updated properly for the can_bulk_split()
case.
The AUTOSET bit in the TXCSR is not being set if the "mult"
factor is greater than 1 for the High Bandwidth ISO case.
But the "mult" factor is also greater than 1 in case of Full speed
bulk transfers with the packet splitting in TXMAXP register
enabled with can_bulk_split().
Without the AUTOSET the DMA transfers will not progress in mode1
[ balbi@ti.com : fix braces placement ]
Signed-off-by: supriya karanth <supriya.karanth@stericsson.com>
Signed-off-by: Praveena NADAHALLY <praveen.nadahally@stericsson.com>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/drivers/usb/musb/musb_host.c b/drivers/usb/musb/musb_host.c
index e9f0fd9..cf3705f 100644
--- a/drivers/usb/musb/musb_host.c
+++ b/drivers/usb/musb/musb_host.c
@@ -634,7 +634,17 @@
mode = 1;
csr |= MUSB_TXCSR_DMAMODE | MUSB_TXCSR_DMAENAB;
/* autoset shouldn't be set in high bandwidth */
- if (qh->hb_mult == 1)
+ /*
+ * Enable Autoset according to table
+ * below
+ * bulk_split hb_mult Autoset_Enable
+ * 0 1 Yes(Normal)
+ * 0 >1 No(High BW ISO)
+ * 1 1 Yes(HS bulk)
+ * 1 >1 Yes(FS bulk)
+ */
+ if (qh->hb_mult == 1 || (qh->hb_mult > 1 &&
+ can_bulk_split(hw_ep->musb, qh->type)))
csr |= MUSB_TXCSR_AUTOSET;
} else {
mode = 0;
@@ -791,17 +801,19 @@
/* protocol/endpoint/interval/NAKlimit */
if (epnum) {
musb_writeb(epio, MUSB_TXTYPE, qh->type_reg);
- if (musb->double_buffer_not_ok)
+ if (musb->double_buffer_not_ok) {
musb_writew(epio, MUSB_TXMAXP,
hw_ep->max_packet_sz_tx);
- else if (can_bulk_split(musb, qh->type))
+ } else if (can_bulk_split(musb, qh->type)) {
+ qh->hb_mult = hw_ep->max_packet_sz_tx
+ / packet_sz;
musb_writew(epio, MUSB_TXMAXP, packet_sz
- | ((hw_ep->max_packet_sz_tx /
- packet_sz) - 1) << 11);
- else
+ | ((qh->hb_mult) - 1) << 11);
+ } else {
musb_writew(epio, MUSB_TXMAXP,
qh->maxpacket |
((qh->hb_mult - 1) << 11));
+ }
musb_writeb(epio, MUSB_TXINTERVAL, qh->intv_reg);
} else {
musb_writeb(epio, MUSB_NAKLIMIT0, qh->intv_reg);