Input: imx_keypad - reset the hardware before enabling
Ensure the hardware is correctly initialized before requesting the
interrupt, otherwise if a key was already touched since power-on the
kernel enters an interrupt loop. To fix this issue we clear pending
interrupt sources. We also have to make sure clk is enabled while
changing the keypad registers.
Signed-off-by: Michael Grzeschik <m.grzeschik@pengutronix.de>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
diff --git a/drivers/input/keyboard/imx_keypad.c b/drivers/input/keyboard/imx_keypad.c
index ff4c0a8..ce68e36 100644
--- a/drivers/input/keyboard/imx_keypad.c
+++ b/drivers/input/keyboard/imx_keypad.c
@@ -358,6 +358,7 @@
/* Inhibit KDI and KRI interrupts. */
reg_val = readw(keypad->mmio_base + KPSR);
reg_val &= ~(KBD_STAT_KRIE | KBD_STAT_KDIE);
+ reg_val |= KBD_STAT_KPKR | KBD_STAT_KPKD;
writew(reg_val, keypad->mmio_base + KPSR);
/* Colums as open drain and disable all rows */
@@ -515,7 +516,9 @@
input_set_drvdata(input_dev, keypad);
/* Ensure that the keypad will stay dormant until opened */
+ clk_enable(keypad->clk);
imx_keypad_inhibit(keypad);
+ clk_disable(keypad->clk);
error = request_irq(irq, imx_keypad_irq_handler, 0,
pdev->name, keypad);