qed: Align CIDs according to DORQ requirement
The Doorbell HW block can be configured at a granularity
of 16 x CIDs, so we need to make sure that the actual number
of CIDs configured would be a multiplication of 16.
Today, when RoCE is enabled - given that the number is unaligned,
doorbelling the higher CIDs would fail to reach the firmware and
would eventually timeout.
Fixes: dbb799c39717 ("qed: Initialize hardware for new protocols")
Signed-off-by: Ram Amrani <Ram.Amrani@cavium.com>
Signed-off-by: Yuval Mintz <Yuval.Mintz@cavium.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/qlogic/qed/qed_cxt.c b/drivers/net/ethernet/qlogic/qed/qed_cxt.c
index d42d03d..7e3a6fe 100644
--- a/drivers/net/ethernet/qlogic/qed/qed_cxt.c
+++ b/drivers/net/ethernet/qlogic/qed/qed_cxt.c
@@ -422,8 +422,9 @@
u32 page_sz = p_mgr->clients[ILT_CLI_CDUC].p_size.val;
u32 cxt_size = CONN_CXT_SIZE(p_hwfn);
u32 elems_per_page = ILT_PAGE_IN_BYTES(page_sz) / cxt_size;
+ u32 align = elems_per_page * DQ_RANGE_ALIGN;
- p_conn->cid_count = roundup(p_conn->cid_count, elems_per_page);
+ p_conn->cid_count = roundup(p_conn->cid_count, align);
}
}