| What: /sys/class/hidraw/hidraw*/device/speed |
| Date: April 2010 |
| Kernel Version: 2.6.35 |
| Contact: linux-bluetooth@vger.kernel.org |
| Description: |
| The /sys/class/hidraw/hidraw*/device/speed file controls |
| reporting speed of Wacom bluetooth tablet. Reading from |
| this file returns 1 if tablet reports in high speed mode |
| or 0 otherwise. Writing to this file one of these values |
| switches reporting speed. |
| |
| What: /sys/bus/usb/devices/<busnum>-<devnum>:<cfg>.<intf>/wacom_led/led |
| Date: August 2011 |
| Contact: linux-input@vger.kernel.org |
| Description: |
| Attribute group for control of the status LEDs and the OLED |
| displays found on the Wacom Intuos 4 M, L, and XL tablets. This |
| attribute group is not available for other Wacom tablets. |
| Therefore its presence implicitly signifies the presence of |
| said LEDs and OLED displays on the tablet device. |
| |
| What: /sys/bus/usb/devices/<busnum>-<devnum>:<cfg>.<intf>/wacom_led/status0_luminance |
| Date: August 2011 |
| Contact: linux-input@vger.kernel.org |
| Description: |
| Writing to this file sets the status LED luminance (0..127) |
| when the stylus does not touch the tablet surface, and no |
| button is pressed on the stylus. This luminance level is |
| normally lower than the level when a button is pressed. |
| |
| What: /sys/bus/usb/devices/<busnum>-<devnum>:<cfg>.<intf>/wacom_led/status1_luminance |
| Date: August 2011 |
| Contact: linux-input@vger.kernel.org |
| Description: |
| Writing to this file sets the status LED luminance (0..127) |
| when the stylus touches the tablet surface, or any button is |
| pressed on the stylus. |
| |
| What: /sys/bus/usb/devices/<busnum>-<devnum>:<cfg>.<intf>/wacom_led/status_led_select |
| Date: August 2011 |
| Contact: linux-input@vger.kernel.org |
| Description: |
| Writing to this file sets which one of the four status LEDs is |
| active (0..3). The other three LEDs are always inactive. By |
| means of specifying "-1" it is possible to set all status LEDs |
| to inactive. |
| |
| What: /sys/bus/usb/devices/<busnum>-<devnum>:<cfg>.<intf>/wacom_led/buttons_luminance |
| Date: August 2011 |
| Contact: linux-input@vger.kernel.org |
| Description: |
| Writing to this file sets the overall luminance level (0..15) |
| of all eight button OLED displays. |
| |
| What: /sys/bus/usb/devices/<busnum>-<devnum>:<cfg>.<intf>/wacom_led/button<n>_rawimg |
| Date: August 2011 |
| Contact: linux-input@vger.kernel.org |
| Description: |
| When writing a 1024 byte raw image in Wacom Intuos 4 |
| interleaving format to the file, the image shows up on Button N |
| of the device. The image is a 64x32 pixel 4-bit gray image. The |
| 1024 byte binary is split up into 16x 64 byte chunks. Each 64 |
| byte chunk encodes the image data for two consecutive lines on |
| the display. The low nibble of each byte contains the first |
| line, and the high nibble contains the second line. |