PCI PM: Follow PCI_PM_CTRL_NO_SOFT_RESET during transitions from D3
According to the PCI PM specification (PCI Bus Power Management
Interface Specification, Rev. 1.2, Section 5.4.1) we are supposed to
reinitialize devices that have PCI_PM_CTRL_NO_SOFT_RESET clear during
all transitions from PCI_D3hot to PCI_D0, but we only do it if the
device's current_state field is equal to PCI_UNKNOWN.
This may lead to problems if a device with PCI_PM_CTRL_NO_SOFT_RESET
unset is put into PCI_D3hot at run time by its driver and
pci_set_power_state() is used to put it back into PCI_D0, because in
that case the device will remain uninitialized after
pci_set_power_state() has returned. Prevent that from happening by
modifying pci_raw_set_power_state() to reinitialize devices with
PCI_PM_CTRL_NO_SOFT_RESET unset during all transitions from D3 to D0.
Cc: stable@kernel.org
Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
Signed-off-by: Jesse Barnes <jbarnes@virtuousgeek.org>
diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c
index 1a91bf9..7615576 100644
--- a/drivers/pci/pci.c
+++ b/drivers/pci/pci.c
@@ -480,6 +480,8 @@
pmcsr &= ~PCI_PM_CTRL_STATE_MASK;
pmcsr |= state;
break;
+ case PCI_D3hot:
+ case PCI_D3cold:
case PCI_UNKNOWN: /* Boot-up */
if ((pmcsr & PCI_PM_CTRL_STATE_MASK) == PCI_D3hot
&& !(pmcsr & PCI_PM_CTRL_NO_SOFT_RESET))