[media] s5p-fimc: Ensure proper s_power() call order in the ISP datapaths
Since the FIMC-IS firmware communicates with an image sensor directly
through the ISP I2C bus controllers the sub-devices power supplies
cannot be simply enabled from left to right or disabled from right
to left along the processing pipeline. Thus a subdev index to call
s_power() on is looked up from a table, rather than doing the op call
based on increasing/decreasing indexes.
Signed-off-by: Sylwester Nawrocki <s.nawrocki@samsung.com>
Signed-off-by: Kyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
diff --git a/drivers/media/platform/s5p-fimc/fimc-mdevice.c b/drivers/media/platform/s5p-fimc/fimc-mdevice.c
index b224899..77075a4d1 100644
--- a/drivers/media/platform/s5p-fimc/fimc-mdevice.c
+++ b/drivers/media/platform/s5p-fimc/fimc-mdevice.c
@@ -128,23 +128,33 @@
*
* Needs to be called with the graph mutex held.
*/
-static int fimc_pipeline_s_power(struct fimc_pipeline *p, bool state)
+static int fimc_pipeline_s_power(struct fimc_pipeline *p, bool on)
{
- unsigned int i;
- int ret;
+ static const u8 seq[2][IDX_MAX - 1] = {
+ { IDX_IS_ISP, IDX_SENSOR, IDX_CSIS, IDX_FLITE },
+ { IDX_CSIS, IDX_FLITE, IDX_SENSOR, IDX_IS_ISP },
+ };
+ int i, ret = 0;
if (p->subdevs[IDX_SENSOR] == NULL)
return -ENXIO;
- for (i = 0; i < IDX_MAX; i++) {
- unsigned int idx = state ? (IDX_MAX - 1) - i : i;
+ for (i = 0; i < IDX_MAX - 1; i++) {
+ unsigned int idx = seq[on][i];
- ret = __subdev_set_power(p->subdevs[idx], state);
+ ret = __subdev_set_power(p->subdevs[idx], on);
+
+
if (ret < 0 && ret != -ENXIO)
- return ret;
+ goto error;
}
-
return 0;
+error:
+ for (; i >= 0; i--) {
+ unsigned int idx = seq[on][i];
+ __subdev_set_power(p->subdevs[idx], !on);
+ }
+ return ret;
}
/**