net: Add ndo_{set|get}_vf_port support for enic dynamic vnics
Add enic ndo_{set|get}_vf_port ops to support setting/getting
port-profile for enic dynamic devices. Enic dynamic devices are just like
normal enic eth devices except dynamic enics require an extra configuration
step to assign a port-profile identifier to the interface before the
interface is useable. Once a port-profile is assigned, link comes up on the
interface and is ready for I/O. The port-profile is used to configure the
network port assigned to the interface. The network port configuration
includes VLAN membership, QoS policies, and port security settings typical
of a data center network.
A dynamic enic initially has a zero-mac address. Before a port-profile is
assigned, a valid non-zero unicast mac address should be assign to the
dynamic enic interface.
Signed-off-by: Scott Feldman <scofeldm@cisco.com>
Signed-off-by: Roopa Prabhu <roprabhu@cisco.com>
diff --git a/drivers/net/enic/vnic_dev.h b/drivers/net/enic/vnic_dev.h
index f5be640..caccce3 100644
--- a/drivers/net/enic/vnic_dev.h
+++ b/drivers/net/enic/vnic_dev.h
@@ -103,8 +103,8 @@
int vnic_dev_hang_notify(struct vnic_dev *vdev);
void vnic_dev_packet_filter(struct vnic_dev *vdev, int directed, int multicast,
int broadcast, int promisc, int allmulti);
-void vnic_dev_add_addr(struct vnic_dev *vdev, u8 *addr);
-void vnic_dev_del_addr(struct vnic_dev *vdev, u8 *addr);
+int vnic_dev_add_addr(struct vnic_dev *vdev, u8 *addr);
+int vnic_dev_del_addr(struct vnic_dev *vdev, u8 *addr);
int vnic_dev_mac_addr(struct vnic_dev *vdev, u8 *mac_addr);
int vnic_dev_raise_intr(struct vnic_dev *vdev, u16 intr);
int vnic_dev_notify_setcmd(struct vnic_dev *vdev,
@@ -124,6 +124,9 @@
int vnic_dev_open(struct vnic_dev *vdev, int arg);
int vnic_dev_open_done(struct vnic_dev *vdev, int *done);
int vnic_dev_init(struct vnic_dev *vdev, int arg);
+int vnic_dev_init_done(struct vnic_dev *vdev, int *done, int *err);
+int vnic_dev_init_prov(struct vnic_dev *vdev, u8 *buf, u32 len);
+int vnic_dev_deinit(struct vnic_dev *vdev);
int vnic_dev_soft_reset(struct vnic_dev *vdev, int arg);
int vnic_dev_soft_reset_done(struct vnic_dev *vdev, int *done);
void vnic_dev_set_intr_mode(struct vnic_dev *vdev,