[TG3]: use TG3_FLG2_5705_PLUS instead of multi-way if's
Replace a number of three-way if statements checking for 5705, 5750,
and 5752 to reference the equivalent TG3_FLG2_5705_PLUS flag instead.
Signed-off-by: John W. Linville <linville@tuxdriver.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/tg3.c b/drivers/net/tg3.c
index 4375eec..7ff598c 100644
--- a/drivers/net/tg3.c
+++ b/drivers/net/tg3.c
@@ -85,9 +85,7 @@
/* hardware minimum and maximum for a single frame's data payload */
#define TG3_MIN_MTU 60
#define TG3_MAX_MTU(tp) \
- ((GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5705 && \
- GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5750 && \
- GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5752) ? 9000 : 1500)
+ (!(tp->tg3_flags2 & TG3_FLG2_5705_PLUS) ? 9000 : 1500)
/* These numbers seem to be hard coded in the NIC firmware somehow.
* You can't change the ring sizes, but you can change where you place
@@ -863,9 +861,7 @@
if ((tp->phy_id & PHY_ID_MASK) == PHY_ID_BCM5401) {
/* Cannot do read-modify-write on 5401 */
tg3_writephy(tp, MII_TG3_AUX_CTRL, 0x4c20);
- } else if (GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5705 &&
- GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5750 &&
- GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5752) {
+ } else if (!(tp->tg3_flags2 & TG3_FLG2_5705_PLUS)) {
u32 phy_reg;
/* Set bit 14 with read-modify-write to preserve other bits */
@@ -877,9 +873,7 @@
/* Set phy register 0x10 bit 0 to high fifo elasticity to support
* jumbo frames transmission.
*/
- if (GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5705 &&
- GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5750 &&
- GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5752) {
+ if (!(tp->tg3_flags2 & TG3_FLG2_5705_PLUS)) {
u32 phy_reg;
if (!tg3_readphy(tp, MII_TG3_EXT_CTRL, &phy_reg))
@@ -8483,9 +8477,7 @@
/* DMA read watermark not used on PCIE */
tp->dma_rwctrl |= 0x00180000;
} else if (!(tp->tg3_flags & TG3_FLAG_PCIX_MODE)) {
- if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5705 ||
- GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5750 ||
- GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5752)
+ if (tp->tg3_flags2 & TG3_FLG2_5705_PLUS)
tp->dma_rwctrl |= 0x003f0000;
else
tp->dma_rwctrl |= 0x003f000f;