| Linus Torvalds | 1da177e | 2005-04-16 15:20:36 -0700 | [diff] [blame^] | 1 | # |
| 2 | # USB Imageing devices configuration |
| 3 | # |
| 4 | comment "USB Imaging devices" |
| 5 | depends on USB |
| 6 | |
| 7 | config USB_MDC800 |
| 8 | tristate "USB Mustek MDC800 Digital Camera support (EXPERIMENTAL)" |
| 9 | depends on USB && EXPERIMENTAL |
| 10 | ---help--- |
| 11 | Say Y here if you want to connect this type of still camera to |
| 12 | your computer's USB port. This driver can be used with gphoto 0.4.3 |
| 13 | and higher (look at <http://www.gphoto.org/>). |
| 14 | To use it create a device node with "mknod /dev/mustek c 180 32" and |
| 15 | configure it in your software. |
| 16 | |
| 17 | To compile this driver as a module, choose M here: the |
| 18 | module will be called mdc800. |
| 19 | |
| 20 | config USB_MICROTEK |
| 21 | tristate "Microtek X6USB scanner support" |
| 22 | depends on USB && SCSI |
| 23 | help |
| 24 | Say Y here if you want support for the Microtek X6USB and |
| 25 | possibly the Phantom 336CX, Phantom C6 and ScanMaker V6U(S)L. |
| 26 | Support for anything but the X6 is experimental. |
| 27 | Please report failures and successes. |
| 28 | The scanner will appear as a scsi generic device to the rest |
| 29 | of the system. Scsi support is required. |
| 30 | This driver can be compiled as a module, called microtek. |