| Sandeep Nair | 41f93af | 2014-02-28 10:47:50 -0500 | [diff] [blame] | 1 | # |
| 2 | # TI SOC drivers |
| 3 | # |
| 4 | menuconfig SOC_TI |
| 5 | bool "TI SOC drivers support" |
| 6 | |
| 7 | if SOC_TI |
| 8 | |
| 9 | config KEYSTONE_NAVIGATOR_QMSS |
| 10 | tristate "Keystone Queue Manager Sub System" |
| 11 | depends on ARCH_KEYSTONE |
| 12 | help |
| 13 | Say y here to support the Keystone multicore Navigator Queue |
| 14 | Manager support. The Queue Manager is a hardware module that |
| 15 | is responsible for accelerating management of the packet queues. |
| 16 | Packets are queued/de-queued by writing/reading descriptor address |
| 17 | to a particular memory mapped location in the Queue Manager module. |
| 18 | |
| 19 | If unsure, say N. |
| 20 | |
| Santosh Shilimkar | 88139ed | 2014-03-30 17:29:04 -0400 | [diff] [blame] | 21 | config KEYSTONE_NAVIGATOR_DMA |
| 22 | tristate "TI Keystone Navigator Packet DMA support" |
| 23 | depends on ARCH_KEYSTONE |
| 24 | help |
| 25 | Say y tp enable support for the Keystone Navigator Packet DMA on |
| 26 | on Keystone family of devices. It sets up the dma channels for the |
| 27 | Queue Manager Sub System. |
| 28 | |
| 29 | If unsure, say N. |
| 30 | |
| Dave Gerlach | cdd5de5 | 2015-09-22 19:14:54 -0500 | [diff] [blame] | 31 | config WKUP_M3_IPC |
| 32 | tristate "TI AMx3 Wkup-M3 IPC Driver" |
| 33 | depends on WKUP_M3_RPROC |
| 34 | depends on OMAP2PLUS_MBOX |
| 35 | help |
| 36 | TI AM33XX and AM43XX have a Cortex M3, the Wakeup M3, to handle |
| 37 | low power transitions. This IPC driver provides the necessary API |
| 38 | to communicate and use the Wakeup M3 for PM features like suspend |
| 39 | resume and boots it using wkup_m3_rproc driver. |
| 40 | |
| Dave Gerlach | 52835d5 | 2017-04-04 08:59:27 -0700 | [diff] [blame^] | 41 | config TI_SCI_PM_DOMAINS |
| 42 | tristate "TI SCI PM Domains Driver" |
| 43 | depends on TI_SCI_PROTOCOL |
| 44 | depends on PM_GENERIC_DOMAINS |
| 45 | help |
| 46 | Generic power domain implementation for TI device implementing |
| 47 | the TI SCI protocol. |
| 48 | |
| 49 | To compile this as a module, choose M here. The module will be |
| 50 | called ti_sci_pm_domains. Note this is needed early in boot before |
| 51 | rootfs may be available. |
| 52 | |
| Sandeep Nair | 41f93af | 2014-02-28 10:47:50 -0500 | [diff] [blame] | 53 | endif # SOC_TI |