| Linus Torvalds | 1da177e | 2005-04-16 15:20:36 -0700 | [diff] [blame] | 1 | # |
| 2 | # SCSI driver configuration for Acorn |
| 3 | # |
| 4 | config SCSI_ACORNSCSI_3 |
| 5 | tristate "Acorn SCSI card (aka30) support" |
| Al Viro | a838e54 | 2005-08-23 22:46:11 +0100 | [diff] [blame^] | 6 | depends on ARCH_ACORN && SCSI && BROKEN |
| Linus Torvalds | 1da177e | 2005-04-16 15:20:36 -0700 | [diff] [blame] | 7 | help |
| 8 | This enables support for the Acorn SCSI card (aka30). If you have an |
| 9 | Acorn system with one of these, say Y. If unsure, say N. |
| 10 | |
| 11 | config SCSI_ACORNSCSI_TAGGED_QUEUE |
| 12 | bool "Support SCSI 2 Tagged queueing" |
| 13 | depends on SCSI_ACORNSCSI_3 |
| 14 | help |
| 15 | Say Y here to enable tagged queuing support on the Acorn SCSI card. |
| 16 | |
| 17 | This is a feature of SCSI-2 which improves performance: the host |
| 18 | adapter can send several SCSI commands to a device's queue even if |
| 19 | previous commands haven't finished yet. Some SCSI devices don't |
| 20 | implement this properly, so the safe answer is N. |
| 21 | |
| 22 | config SCSI_ACORNSCSI_SYNC |
| 23 | bool "Support SCSI 2 Synchronous Transfers" |
| 24 | depends on SCSI_ACORNSCSI_3 |
| 25 | help |
| 26 | Say Y here to enable synchronous transfer negotiation with all |
| 27 | targets on the Acorn SCSI card. |
| 28 | |
| 29 | In general, this improves performance; however some SCSI devices |
| 30 | don't implement it properly, so the safe answer is N. |
| 31 | |
| 32 | config SCSI_ARXESCSI |
| 33 | tristate "ARXE SCSI support" |
| 34 | depends on ARCH_ACORN && SCSI |
| 35 | help |
| 36 | Around 1991, Arxe Systems Limited released a high density floppy |
| 37 | disc interface for the Acorn Archimedes range, to allow the use of |
| 38 | HD discs from the then new A5000 on earlier models. This interface |
| 39 | was either sold on its own or with an integral SCSI controller. |
| 40 | Technical details on this NCR53c94-based device are available at |
| 41 | <http://www.cryton.demon.co.uk/acornbits/scsi_arxe.html> |
| 42 | Say Y here to compile in support for the SCSI controller. |
| 43 | |
| 44 | config SCSI_CUMANA_2 |
| 45 | tristate "CumanaSCSI II support" |
| 46 | depends on ARCH_ACORN && SCSI |
| 47 | help |
| 48 | This enables support for the Cumana SCSI II card. If you have an |
| 49 | Acorn system with one of these, say Y. If unsure, say N. |
| 50 | |
| 51 | config SCSI_EESOXSCSI |
| 52 | tristate "EESOX support" |
| 53 | depends on ARCH_ACORN && SCSI |
| 54 | help |
| 55 | This enables support for the EESOX SCSI card. If you have an Acorn |
| 56 | system with one of these, say Y, otherwise say N. |
| 57 | |
| 58 | config SCSI_POWERTECSCSI |
| 59 | tristate "PowerTec support" |
| 60 | depends on ARCH_ACORN && SCSI |
| 61 | help |
| 62 | This enables support for the Powertec SCSI card on Acorn systems. If |
| 63 | you have one of these, say Y. If unsure, say N. |
| 64 | |
| 65 | comment "The following drivers are not fully supported" |
| 66 | depends on ARCH_ACORN && EXPERIMENTAL |
| 67 | |
| 68 | config SCSI_CUMANA_1 |
| 69 | tristate "CumanaSCSI I support (EXPERIMENTAL)" |
| 70 | depends on ARCH_ACORN && EXPERIMENTAL && SCSI |
| 71 | help |
| 72 | This enables support for the Cumana SCSI I card. If you have an |
| 73 | Acorn system with one of these, say Y. If unsure, say N. |
| 74 | |
| 75 | config SCSI_ECOSCSI |
| 76 | tristate "EcoScsi support (EXPERIMENTAL)" |
| 77 | depends on ARCH_ACORN && EXPERIMENTAL && (ARCH_ARC || ARCH_A5K) && SCSI |
| 78 | help |
| 79 | This enables support for the EcoSCSI card -- a small card that sits |
| 80 | in the Econet socket. If you have an Acorn system with one of these, |
| 81 | say Y. If unsure, say N. |
| 82 | |
| 83 | config SCSI_OAK1 |
| 84 | tristate "Oak SCSI support (EXPERIMENTAL)" |
| 85 | depends on ARCH_ACORN && EXPERIMENTAL && SCSI |
| 86 | help |
| 87 | This enables support for the Oak SCSI card. If you have an Acorn |
| 88 | system with one of these, say Y. If unsure, say N. |
| 89 | |