dsa: Register netdev before phy
When the phy is connected, an info message is printed. If the netdev
it is attached to has not been registered yet, the name
'uninitialised' in the output. By registering the netdev first, then
connecting they phy, we can avoid this.
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/dsa/slave.c b/net/dsa/slave.c
index 2771713..40b9ca7 100644
--- a/net/dsa/slave.c
+++ b/net/dsa/slave.c
@@ -1189,13 +1189,6 @@
p->old_link = -1;
p->old_duplex = -1;
- ret = dsa_slave_phy_setup(p, slave_dev);
- if (ret) {
- netdev_err(master, "error %d setting up slave phy\n", ret);
- free_netdev(slave_dev);
- return ret;
- }
-
ds->ports[port] = slave_dev;
ret = register_netdev(slave_dev);
if (ret) {
@@ -1209,6 +1202,13 @@
netif_carrier_off(slave_dev);
+ ret = dsa_slave_phy_setup(p, slave_dev);
+ if (ret) {
+ netdev_err(master, "error %d setting up slave phy\n", ret);
+ free_netdev(slave_dev);
+ return ret;
+ }
+
return 0;
}