ARM: OMAP4: VC: setup I2C parameters based on board data
VC code now provides a table of pre-calculated I2C setup parameters,
which will be used based on the capacitance value calculated for the I2C
trace on the PCB. A default trace length of 6.3cm is used unless board
defines its own value during init. The parameters set will be the I2C
internal pull setup and the I2C timing parameters for high speed use
mode. Full speed mode is not supported as of now.
Signed-off-by: Tero Kristo <t-kristo@ti.com>
Signed-off-by: Kevin Hilman <khilman@ti.com>
diff --git a/arch/arm/mach-omap2/pm.h b/arch/arm/mach-omap2/pm.h
index 4290288..4db7b23 100644
--- a/arch/arm/mach-omap2/pm.h
+++ b/arch/arm/mach-omap2/pm.h
@@ -132,9 +132,11 @@
#ifdef CONFIG_PM
extern void omap_pm_setup_oscillator(u32 tstart, u32 tshut);
extern void omap_pm_get_oscillator(u32 *tstart, u32 *tshut);
+extern void omap_pm_setup_sr_i2c_pcb_length(u32 mm);
#else
static inline void omap_pm_setup_oscillator(u32 tstart, u32 tshut) { }
static inline void omap_pm_get_oscillator(u32 *tstart, u32 *tshut) { }
+static inline void omap_pm_setup_sr_i2c_pcb_length(u32 mm) { }
#endif
#endif