[PATCH] i810fb: Do not probe the third i2c bus by default
Some time before 2.6.15, a third DDC channel was added to i810fb. On
systems where these ddc pins are not connected, the probe takes about 10
seconds.
Add a boot/module option for i810fb to explicitly probe for the 3rd ddc bus
if needed.
Signed-off-by: Antonino Daplas <adaplas@pol.net>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/video/i810/i810_main.c b/drivers/video/i810/i810_main.c
index 266d0ab..d8467c0 100644
--- a/drivers/video/i810/i810_main.c
+++ b/drivers/video/i810/i810_main.c
@@ -149,6 +149,7 @@
static int sync __devinitdata;
static int extvga __devinitdata;
static int dcolor __devinitdata;
+static int ddc3 __devinitdata = 2;
/*------------------------------------------------------------*/
@@ -1763,6 +1764,8 @@
if (sync)
par->dev_flags |= ALWAYS_SYNC;
+ par->ddc_num = ddc3;
+
if (bpp < 8)
bpp = 8;
@@ -1885,7 +1888,7 @@
int found = 0;
#ifdef CONFIG_FB_I810_I2C
int i;
- int err;
+ int err = 1;
struct i810fb_par *par = info->par;
#endif
@@ -1895,8 +1898,8 @@
#ifdef CONFIG_FB_I810_I2C
i810_create_i2c_busses(par);
- for (i = 0; i < 4; i++) {
- err = i810_probe_i2c_connector(info, &par->edid, i+1);
+ for (i = 0; i < par->ddc_num + 1; i++) {
+ err = i810_probe_i2c_connector(info, &par->edid, i);
if (!err)
break;
}
@@ -1983,6 +1986,8 @@
vsync2 = simple_strtoul(this_opt+7, NULL, 0);
else if (!strncmp(this_opt, "dcolor", 6))
dcolor = 1;
+ else if (!strncmp(this_opt, "ddc3", 4))
+ ddc3 = 3;
else
mode_option = this_opt;
}
@@ -2190,6 +2195,8 @@
module_param(dcolor, bool, 0);
MODULE_PARM_DESC(dcolor, "use DirectColor visuals"
" (default = 0 = TrueColor)");
+module_param(ddc3, bool, 0);
+MODULE_PARM_DESC(ddc3, "Probe DDC bus 3 (default = 0 = no)");
module_param(mode_option, charp, 0);
MODULE_PARM_DESC(mode_option, "Specify initial video mode");