be2net: Fix unconditional enabling of Rx interface options
The driver currently requests the firmware to enable rx_interface options
without considering if the interface was created with that capability.
This could cause commands to firmware to fail.
To avoid this, enable only those options on an interface if the interface
was created with that capability.
Signed-off-by: Ajit Khaparde <ajit.khaparde@emulex.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/emulex/benet/be_cmds.h b/drivers/net/ethernet/emulex/benet/be_cmds.h
index edf3e8a..0075686 100644
--- a/drivers/net/ethernet/emulex/benet/be_cmds.h
+++ b/drivers/net/ethernet/emulex/benet/be_cmds.h
@@ -1984,7 +1984,7 @@
char *fw_on_flash);
int be_cmd_modify_eqd(struct be_adapter *adapter, struct be_set_eqd *, int num);
int be_cmd_vlan_config(struct be_adapter *adapter, u32 if_id, u16 *vtag_array,
- u32 num, bool untagged, bool promiscuous);
+ u32 num, bool promiscuous);
int be_cmd_rx_filter(struct be_adapter *adapter, u32 flags, u32 status);
int be_cmd_set_flow_control(struct be_adapter *adapter, u32 tx_fc, u32 rx_fc);
int be_cmd_get_flow_control(struct be_adapter *adapter, u32 *tx_fc, u32 *rx_fc);