[PATCH] Support 100 MHz frequency transitions
Future versions of the Opteron processor may support
frequency transitions of 100 MHz, instead of the=20
current 200 MHz. This patch enables the powernow-k8
driver to transition to an odd FID code, indicating
a multiple of 100 MHz frequency.
Signed-off-by: Jacob Shin <jacob.shin@amd.com>
Signed-off-by: Mark Langsdorf <mark.langsdorf@amd.com>
Signed-off-by: Dave Jones <davej@redhat.com>
diff --git a/arch/i386/kernel/cpu/cpufreq/powernow-k8.h b/arch/i386/kernel/cpu/cpufreq/powernow-k8.h
index b1e85bb..d0de37d 100644
--- a/arch/i386/kernel/cpu/cpufreq/powernow-k8.h
+++ b/arch/i386/kernel/cpu/cpufreq/powernow-k8.h
@@ -42,7 +42,7 @@
#define CPUID_XFAM 0x0ff00000 /* extended family */
#define CPUID_XFAM_K8 0
#define CPUID_XMOD 0x000f0000 /* extended model */
-#define CPUID_XMOD_REV_F 0x00040000
+#define CPUID_XMOD_REV_G 0x00060000
#define CPUID_USE_XFAM_XMOD 0x00000f00
#define CPUID_GET_MAX_CAPABILITIES 0x80000000
#define CPUID_FREQ_VOLT_CAPABILITIES 0x80000007
@@ -86,13 +86,14 @@
* low fid table
* - lowest entry in the high fid table must be a <= 200MHz + 2 * the entry
* in the low fid table
- * - the parts can only step at 200 MHz intervals, so 1.9 GHz is never valid
+ * - the parts can only step at <= 200 MHz intervals, odd fid values are
+ * supported in revision G and later revisions.
* - lowest frequency must be >= interprocessor hypertransport link speed
* (only applies to MP systems obviously)
*/
/* fids (frequency identifiers) are arranged in 2 tables - lo and hi */
-#define LO_FID_TABLE_TOP 6 /* fid values marking the boundary */
+#define LO_FID_TABLE_TOP 7 /* fid values marking the boundary */
#define HI_FID_TABLE_BOTTOM 8 /* between the low and high tables */
#define LO_VCOFREQ_TABLE_TOP 1400 /* corresponding vco frequency values */
@@ -106,7 +107,7 @@
#define MIN_FREQ 800 /* Min and max freqs, per spec */
#define MAX_FREQ 5000
-#define INVALID_FID_MASK 0xffffffc1 /* not a valid fid if these bits are set */
+#define INVALID_FID_MASK 0xffffffc0 /* not a valid fid if these bits are set */
#define INVALID_VID_MASK 0xffffffc0 /* not a valid vid if these bits are set */
#define VID_OFF 0x3f