rt2x00: Fix race conditions in flag handling
Some of the flags should be accessed atomically to
prevent race conditions. The flags that are most important
are those that can change often and indicate the actual
state of the device, queue or queue entry.
The big flag rename was done to move all state flags to
the same naming type as the other rt2x00dev flags and
made sure all places where the flags were used were changed. ;)
Thanks to Stephen for most of the queue flags updates,
which fixes some of the most obvious consequences of the
race conditions. Among those the notorious:
rt2x00queue_write_tx_frame: Error - Arrived at non-free entry in the non-full queue 0.
rt2x00queue_write_tx_frame: Error - Arrived at non-free entry in the non-full queue 0.
rt2x00queue_write_tx_frame: Error - Arrived at non-free entry in the non-full queue 0.
Signed-off-by: Stephen Blackheath <tramp.enshrine.stephen@blacksapphire.com>
Signed-off-by: Ivo van Doorn <IvDoorn@gmail.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/rt2x00/rt2x00config.c b/drivers/net/wireless/rt2x00/rt2x00config.c
index ea37c79..ca051f5 100644
--- a/drivers/net/wireless/rt2x00/rt2x00config.c
+++ b/drivers/net/wireless/rt2x00/rt2x00config.c
@@ -121,7 +121,7 @@
* Antenna setup changes require the RX to be disabled,
* else the changes will be ignored by the device.
*/
- if (test_bit(DEVICE_ENABLED_RADIO, &rt2x00dev->flags))
+ if (test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags))
rt2x00lib_toggle_rx(rt2x00dev, STATE_RADIO_RX_OFF_LINK);
/*
@@ -136,7 +136,7 @@
rt2x00dev->link.ant.active.rx = libconf.ant.rx;
rt2x00dev->link.ant.active.tx = libconf.ant.tx;
- if (test_bit(DEVICE_ENABLED_RADIO, &rt2x00dev->flags))
+ if (test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags))
rt2x00lib_toggle_rx(rt2x00dev, STATE_RADIO_RX_ON_LINK);
}