net: fec: workaround stop tx during errata ERR006358
If the ready bit in the transmit buffer descriptor (TxBD[R])
is previously detected as not set during a prior frame transmission,
then the ENET_TDAR[TDAR] bit is cleared at a later time, even if
additional TxBDs were added to the ring and the ENET_TDAR[TDAR]
bit is set. This results in frames not being transmitted until
there is a 0-to-1 transition on ENET_TDAR[TDAR].
Workarounds:
code can use the transmit frame interrupt flag (ENET_EIR[TXF])
as a method to detect whether the ENET has completed transmission
and the ENET_TDAR[TDAR] has been cleared. If ENET_TDAR[TDAR] is
detected as cleared when packets are queued and waiting for transmit,
then a write to the TDAR bit will restart TxBD processing.
This case main happen when loading is light. A ethernet package may
not send out utile next package put into tx queue.
How to test:
while [ true ]
do
ping <IP> -s 10000 -w 4
ping <IP> -s 6000 -w 2
ping <IP> -s 4000 -w 2
ping <IP> -s 10000 -w 2
done
You will see below result in overnight test.
6008 bytes from 10.192.242.116: seq=1 ttl=128 time=0.722 ms
4008 bytes from 10.192.242.116: seq=0 ttl=128 time=1001.008 ms
4008 bytes from 10.192.242.116: seq=1 ttl=128 time=1.010 ms
10008 bytes from 10.192.242.116: seq=0 ttl=128 time=0.896 ms
After apply this patch, >1000ms delay disappear.
Signed-off-by: Frank Li <Frank.Li@freescale.com>
Acked-by: Fugang Duan <B38611@freescale.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/freescale/fec_main.c b/drivers/net/ethernet/freescale/fec_main.c
index f0f0e96..0dda454 100644
--- a/drivers/net/ethernet/freescale/fec_main.c
+++ b/drivers/net/ethernet/freescale/fec_main.c
@@ -93,6 +93,20 @@
#define FEC_QUIRK_HAS_CSUM (1 << 5)
/* Controller has hardware vlan support */
#define FEC_QUIRK_HAS_VLAN (1 << 6)
+/* ENET IP errata ERR006358
+ *
+ * If the ready bit in the transmit buffer descriptor (TxBD[R]) is previously
+ * detected as not set during a prior frame transmission, then the
+ * ENET_TDAR[TDAR] bit is cleared at a later time, even if additional TxBDs
+ * were added to the ring and the ENET_TDAR[TDAR] bit is set. This results in
+ * If the ready bit in the transmit buffer descriptor (TxBD[R]) is previously
+ * detected as not set during a prior frame transmission, then the
+ * ENET_TDAR[TDAR] bit is cleared at a later time, even if additional TxBDs
+ * were added to the ring and the ENET_TDAR[TDAR] bit is set. This results in
+ * frames not being transmitted until there is a 0-to-1 transition on
+ * ENET_TDAR[TDAR].
+ */
+#define FEC_QUIRK_ERR006358 (1 << 7)
static struct platform_device_id fec_devtype[] = {
{
@@ -112,7 +126,7 @@
.name = "imx6q-fec",
.driver_data = FEC_QUIRK_ENET_MAC | FEC_QUIRK_HAS_GBIT |
FEC_QUIRK_HAS_BUFDESC_EX | FEC_QUIRK_HAS_CSUM |
- FEC_QUIRK_HAS_VLAN,
+ FEC_QUIRK_HAS_VLAN | FEC_QUIRK_ERR006358,
}, {
.name = "mvf600-fec",
.driver_data = FEC_QUIRK_ENET_MAC,
@@ -275,7 +289,7 @@
struct fec_enet_private *fep = netdev_priv(ndev);
const struct platform_device_id *id_entry =
platform_get_device_id(fep->pdev);
- struct bufdesc *bdp;
+ struct bufdesc *bdp, *bdp_pre;
void *bufaddr;
unsigned short status;
unsigned int index;
@@ -370,6 +384,15 @@
ebdp->cbd_esc |= BD_ENET_TX_PINS;
}
}
+
+ bdp_pre = fec_enet_get_prevdesc(bdp, fep->bufdesc_ex);
+ if ((id_entry->driver_data & FEC_QUIRK_ERR006358) &&
+ !(bdp_pre->cbd_sc & BD_ENET_TX_READY)) {
+ fep->delay_work.trig_tx = true;
+ schedule_delayed_work(&(fep->delay_work.delay_work),
+ msecs_to_jiffies(1));
+ }
+
/* If this was the last BD in the ring, start at the beginning again. */
if (status & BD_ENET_TX_WRAP)
bdp = fep->tx_bd_base;
@@ -689,6 +712,11 @@
fec_restart(fep->netdev, fep->full_duplex);
netif_wake_queue(fep->netdev);
}
+
+ if (fep->delay_work.trig_tx) {
+ fep->delay_work.trig_tx = false;
+ writel(0, fep->hwp + FEC_X_DES_ACTIVE);
+ }
}
static void