diff --git a/arch/mips/netlogic/Kconfig b/arch/mips/netlogic/Kconfig
index 3c05bf9..e0873a3 100644
--- a/arch/mips/netlogic/Kconfig
+++ b/arch/mips/netlogic/Kconfig
@@ -2,13 +2,22 @@
 
 if NLM_XLP_BOARD
 config DT_XLP_EVP
-	bool "Built-in device tree for XLP EVP/SVP boards"
+	bool "Built-in device tree for XLP EVP boards"
 	default y
 	help
-	  Add an FDT blob for XLP EVP and SVP boards into the kernel.
+	  Add an FDT blob for XLP EVP boards into the kernel.
 	  This DTB will be used if the firmware does not pass in a DTB
-          pointer to the kernel.  The corresponding DTS file is at
-          arch/mips/netlogic/dts/xlp_evp.dts
+	  pointer to the kernel.  The corresponding DTS file is at
+	  arch/mips/netlogic/dts/xlp_evp.dts
+
+config DT_XLP_SVP
+	bool "Built-in device tree for XLP SVP boards"
+	default y
+	help
+	  Add an FDT blob for XLP VP boards into the kernel.
+	  This DTB will be used if the firmware does not pass in a DTB
+	  pointer to the kernel.  The corresponding DTS file is at
+	  arch/mips/netlogic/dts/xlp_svp.dts
 
 config NLM_MULTINODE
 	bool "Support for multi-chip boards"
diff --git a/arch/mips/netlogic/dts/Makefile b/arch/mips/netlogic/dts/Makefile
index d117d46..aecb6fa 100644
--- a/arch/mips/netlogic/dts/Makefile
+++ b/arch/mips/netlogic/dts/Makefile
@@ -1 +1,2 @@
 obj-$(CONFIG_DT_XLP_EVP) := xlp_evp.dtb.o
+obj-$(CONFIG_DT_XLP_SVP) += xlp_svp.dtb.o
diff --git a/arch/mips/netlogic/dts/xlp_evp.dts b/arch/mips/netlogic/dts/xlp_evp.dts
index 7628b54..e14f423 100644
--- a/arch/mips/netlogic/dts/xlp_evp.dts
+++ b/arch/mips/netlogic/dts/xlp_evp.dts
@@ -20,7 +20,7 @@
 		#address-cells = <2>;
 		#size-cells = <1>;
 		compatible = "simple-bus";
-		ranges = <0 0  0 0x18000000  0x04000000	  // PCIe CFG
+		ranges = <0 0  0 0x18000000  0x04000000   // PCIe CFG
 			  1 0  0 0x16000000  0x01000000>; // GBU chipselects
 
 		serial0: serial@30000 {
diff --git a/arch/mips/netlogic/dts/xlp_svp.dts b/arch/mips/netlogic/dts/xlp_svp.dts
new file mode 100644
index 0000000..8af4bdb
--- /dev/null
+++ b/arch/mips/netlogic/dts/xlp_svp.dts
@@ -0,0 +1,124 @@
+/*
+ * XLP3XX Device Tree Source for SVP boards
+ */
+
+/dts-v1/;
+/ {
+	model = "netlogic,XLP-SVP";
+	compatible = "netlogic,xlp";
+	#address-cells = <2>;
+	#size-cells = <2>;
+
+	memory {
+		device_type = "memory";
+		reg =  <0 0x00100000 0 0x0FF00000	// 255M at 1M
+			0 0x20000000 0 0xa0000000	// 2560M at 512M
+			0 0xe0000000 0 0x40000000>;
+	};
+
+	soc {
+		#address-cells = <2>;
+		#size-cells = <1>;
+		compatible = "simple-bus";
+		ranges = <0 0  0 0x18000000  0x04000000   // PCIe CFG
+			  1 0  0 0x16000000  0x01000000>; // GBU chipselects
+
+		serial0: serial@30000 {
+			device_type = "serial";
+			compatible = "ns16550";
+			reg = <0 0x30100 0xa00>;
+			reg-shift = <2>;
+			reg-io-width = <4>;
+			clock-frequency = <133333333>;
+			interrupt-parent = <&pic>;
+			interrupts = <17>;
+		};
+		serial1: serial@31000 {
+			device_type = "serial";
+			compatible = "ns16550";
+			reg = <0 0x31100 0xa00>;
+			reg-shift = <2>;
+			reg-io-width = <4>;
+			clock-frequency = <133333333>;
+			interrupt-parent = <&pic>;
+			interrupts = <18>;
+		};
+		i2c0: ocores@32000 {
+			compatible = "opencores,i2c-ocores";
+			#address-cells = <1>;
+			#size-cells = <0>;
+			reg = <0 0x32100 0xa00>;
+			reg-shift = <2>;
+			reg-io-width = <4>;
+			clock-frequency = <32000000>;
+			interrupt-parent = <&pic>;
+			interrupts = <30>;
+		};
+		i2c1: ocores@33000 {
+			compatible = "opencores,i2c-ocores";
+			#address-cells = <1>;
+			#size-cells = <0>;
+			reg = <0 0x33100 0xa00>;
+			reg-shift = <2>;
+			reg-io-width = <4>;
+			clock-frequency = <32000000>;
+			interrupt-parent = <&pic>;
+			interrupts = <31>;
+
+			rtc@68 {
+				compatible = "dallas,ds1374";
+				reg = <0x68>;
+			};
+
+			dtt@4c {
+				compatible = "national,lm90";
+				reg = <0x4c>;
+			};
+		};
+		pic: pic@4000 {
+			interrupt-controller;
+			#address-cells = <0>;
+			#interrupt-cells = <1>;
+			reg = <0 0x4000 0x200>;
+		};
+
+		nor_flash@1,0 {
+			compatible = "cfi-flash";
+			#address-cells = <1>;
+			#size-cells = <1>;
+			bank-width = <2>;
+			reg = <1 0 0x1000000>;
+
+			partition@0 {
+				label = "x-loader";
+				reg = <0x0 0x100000>; /* 1M */
+				read-only;
+			};
+
+			partition@100000 {
+				label = "u-boot";
+				reg = <0x100000 0x100000>; /* 1M */
+			};
+
+			partition@200000 {
+				label = "kernel";
+				reg = <0x200000 0x500000>; /* 5M */
+			};
+
+			partition@700000 {
+				label = "rootfs";
+				reg = <0x700000 0x800000>; /* 8M */
+			};
+
+			partition@f00000 {
+				label = "env";
+				reg = <0xf00000 0x100000>; /* 1M */
+				read-only;
+			};
+		};
+	};
+
+	chosen {
+		bootargs = "console=ttyS0,115200 rdinit=/sbin/init";
+	};
+};
diff --git a/arch/mips/netlogic/xlp/setup.c b/arch/mips/netlogic/xlp/setup.c
index 4894d62..af31914 100644
--- a/arch/mips/netlogic/xlp/setup.c
+++ b/arch/mips/netlogic/xlp/setup.c
@@ -56,7 +56,7 @@
 struct nlm_soc_info nlm_nodes[NLM_NR_NODES];
 cpumask_t nlm_cpumask = CPU_MASK_CPU0;
 unsigned int nlm_threads_per_core;
-extern u32 __dtb_start[];
+extern u32 __dtb_xlp_evp_begin[], __dtb_xlp_svp_begin[], __dtb_start[];
 
 static void nlm_linux_exit(void)
 {
@@ -82,8 +82,24 @@
 	 * 64-bit, so convert pointer.
 	 */
 	fdtp = (void *)(long)fw_arg0;
-	if (!fdtp)
-		fdtp = __dtb_start;
+	if (!fdtp) {
+		switch (current_cpu_data.processor_id & 0xff00) {
+#ifdef CONFIG_DT_XLP_SVP
+		case PRID_IMP_NETLOGIC_XLP3XX:
+			fdtp = __dtb_xlp_svp_begin;
+			break;
+#endif
+#ifdef CONFIG_DT_XLP_EVP
+		case PRID_IMP_NETLOGIC_XLP8XX:
+			fdtp = __dtb_xlp_evp_begin;
+			break;
+#endif
+		default:
+			/* Pick a built-in if any, and hope for the best */
+			fdtp = __dtb_start;
+			break;
+		}
+	}
 	fdtp = phys_to_virt(__pa(fdtp));
 	early_init_devtree(fdtp);
 }