ath10k: set the UART baud rate to 19200
When configuring the host_interests over BMI, set the UART
baud rate to 19200. This is valid for QCA988X_2.0 devices.
kvalo: found during code review, there should not be any functionality
changes
Signed-off-by: Bartosz Markowski <bartosz.markowski@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath10k/core.c b/drivers/net/wireless/ath/ath10k/core.c
index 4f2b0e7..8a68839 100644
--- a/drivers/net/wireless/ath/ath10k/core.c
+++ b/drivers/net/wireless/ath/ath10k/core.c
@@ -435,6 +435,13 @@
return ret;
}
+ /* Set the UART baud rate to 19200. */
+ ret = ath10k_bmi_write32(ar, hi_desired_baud_rate, 19200);
+ if (ret) {
+ ath10k_warn("could not set the baud rate (%d)\n", ret);
+ return ret;
+ }
+
ath10k_info("UART prints enabled\n");
return 0;
}