bnx2: convert to net_device_ops
Convert driver to new net_device_ops. Compile tested only.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bnx2.c b/drivers/net/bnx2.c
index fe80221..8f1cd7c 100644
--- a/drivers/net/bnx2.c
+++ b/drivers/net/bnx2.c
@@ -7707,6 +7707,25 @@
}
}
+static const struct net_device_ops bnx2_netdev_ops = {
+ .ndo_open = bnx2_open,
+ .ndo_start_xmit = bnx2_start_xmit,
+ .ndo_stop = bnx2_close,
+ .ndo_get_stats = bnx2_get_stats,
+ .ndo_set_rx_mode = bnx2_set_rx_mode,
+ .ndo_do_ioctl = bnx2_ioctl,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = bnx2_change_mac_addr,
+ .ndo_change_mtu = bnx2_change_mtu,
+ .ndo_tx_timeout = bnx2_tx_timeout,
+#ifdef BCM_VLAN
+ .ndo_vlan_rx_register = bnx2_vlan_rx_register,
+#endif
+#if defined(HAVE_POLL_CONTROLLER) || defined(CONFIG_NET_POLL_CONTROLLER)
+ .ndo_poll_controller = poll_bnx2,
+#endif
+};
+
static int __devinit
bnx2_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
{
@@ -7731,28 +7750,13 @@
return rc;
}
- dev->open = bnx2_open;
- dev->hard_start_xmit = bnx2_start_xmit;
- dev->stop = bnx2_close;
- dev->get_stats = bnx2_get_stats;
- dev->set_rx_mode = bnx2_set_rx_mode;
- dev->do_ioctl = bnx2_ioctl;
- dev->set_mac_address = bnx2_change_mac_addr;
- dev->change_mtu = bnx2_change_mtu;
- dev->tx_timeout = bnx2_tx_timeout;
+ dev->netdev_ops = &bnx2_netdev_ops;
dev->watchdog_timeo = TX_TIMEOUT;
-#ifdef BCM_VLAN
- dev->vlan_rx_register = bnx2_vlan_rx_register;
-#endif
dev->ethtool_ops = &bnx2_ethtool_ops;
bp = netdev_priv(dev);
bnx2_init_napi(bp);
-#if defined(HAVE_POLL_CONTROLLER) || defined(CONFIG_NET_POLL_CONTROLLER)
- dev->poll_controller = poll_bnx2;
-#endif
-
pci_set_drvdata(pdev, dev);
memcpy(dev->dev_addr, bp->mac_addr, 6);