usb: gadget: add SS descriptors to Ethernet gadget
Add SuperSpeed descriptors to the Network USB
function drivers.
This has been lightly tested using a Linux host.
I was able to ssh from device to host and host to
device, no obvious problems seen.
Signed-off-by: Paul Zimmerman <paulz@synopsys.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/drivers/usb/gadget/u_ether.c b/drivers/usb/gadget/u_ether.c
index b91363e..dfed4c1 100644
--- a/drivers/usb/gadget/u_ether.c
+++ b/drivers/usb/gadget/u_ether.c
@@ -97,16 +97,17 @@
static unsigned qmult = 5;
module_param(qmult, uint, S_IRUGO|S_IWUSR);
-MODULE_PARM_DESC(qmult, "queue length multiplier at high speed");
+MODULE_PARM_DESC(qmult, "queue length multiplier at high/super speed");
#else /* full speed (low speed doesn't do bulk) */
#define qmult 1
#endif
-/* for dual-speed hardware, use deeper queues at highspeed */
+/* for dual-speed hardware, use deeper queues at high/super speed */
static inline int qlen(struct usb_gadget *gadget)
{
- if (gadget_is_dualspeed(gadget) && gadget->speed == USB_SPEED_HIGH)
+ if (gadget_is_dualspeed(gadget) && (gadget->speed == USB_SPEED_HIGH ||
+ gadget->speed == USB_SPEED_SUPER))
return qmult * DEFAULT_QLEN;
else
return DEFAULT_QLEN;
@@ -598,9 +599,10 @@
req->length = length;
- /* throttle highspeed IRQ rate back slightly */
+ /* throttle high/super speed IRQ rate back slightly */
if (gadget_is_dualspeed(dev->gadget))
- req->no_interrupt = (dev->gadget->speed == USB_SPEED_HIGH)
+ req->no_interrupt = (dev->gadget->speed == USB_SPEED_HIGH ||
+ dev->gadget->speed == USB_SPEED_SUPER)
? ((atomic_read(&dev->tx_qlen) % qmult) != 0)
: 0;